Thermador C271 Installation Instructions Manual

Manual is about: Built-in Convection Ovens

Summary of C271

  • Page 1

    Installation instructions for thermador ® built-in electric ovens models: c272 / c302 / cm302 / cj302 / c271 / c301 / cm301 s272 / sc272 / scd272 / s302 / sc302 / scd302 / s301 / sc301 / smw272 / sm272 timer 2 stop time timer 1 clock cook time oven light 1 4 7 8 5 2 3 6 9 0 upper oven broil convecti...

  • Page 2

    Page 2 the cabinet cutout dimensions for wall mounted and under the counter installations are shown in figs. 2 and 3, respectively. It is good practice, when oven is installed at the end of a cabinet run, adjacent to a perpendicular wall or cabinet door, to allow at least 1/4" space between the side...

  • Page 3

    Page 3 fig. 2- cabinet cutout - wall mounted installation refer to dimensions for specific ovens on page 4 front view side view floor line f g double oven location of conduit box exposed edge must be a finish-cut d recommended 2" diameter hole (4.5 cm) frame overlap (top) 3/8" (1, 0 cm) cabinet appr...

  • Page 4

    Page 4 fig. 2- cabinet cutout - wall mounted installation * add 1/16" for stainless steel ovens (s- series ovens only) ** add 1/8" for stainless steel ovens (s- series ovens only) *** measured from cabinet face, largest door. 27" built-in electric double wall ovens: c272, s272, sc272, scd272 cabinet...

  • Page 5

    Page 5 under the counter units — a single oven (s301, sc301, c301 or cm301) installed under the counter allows for the installation of most thermador gas or electric non-cook'n'vent® model cooktops. (see table 1 for recommended cooktop models.) downdraft units cannot be installed in this configurati...

  • Page 6

    Page 6 step 3: electrical installation all model ovens on the front cover are dual rated, designed to be connected to either 120/240v ac or 120/ 208v ac, 60 hz, 4 wire, single-phase power supply. The s301 and sc301 require a 20-amp circuit. The c271, c301, cm301 smw272 and sm272 require a 30-amp cir...

  • Page 7

    Page 7 208v electrical hookup applies to c271, c272, c301, c302, cm302 and cj302 models only. Your oven has been preset to be hooked up to 240v. 1. Turn off the oven(s). 2. Open the upper oven door. 3. Press and hold the upper off pad in a double oven or the off pad in a single oven. 4. While the up...

  • Page 8

    Step 5: installing the bottom trim install the bottom vent trim and se- cure with (2) screws provided, one at each top end corner of the trim. The sheet metal bottom of the oven should be under the trim, except for the section at the center. To install the screws, open the door. The holes are visibl...