1. DL manuals
  2. Thermador
  3. Oven
  4. C271
  5. Installation Instructions Manual

Thermador C271 Installation Instructions Manual

Manual is about: Built-in Convection Ovens

Summary of C271

  • Page 1

    Installation instructions for thermador ® built-in electric ovens models: c272 / c302 / cm302 / cj302 / cj301/ c271 / c301 / cm301 sc272 / scd272 / sc301 / sc302 / scd302 / smw272 / sm272 timer 2 stop time timer 1 clock cook time oven light 1 4 7 8 5 2 3 6 9 0 upper oven broil convection roast self ...

  • Page 2: Warning

    Page 2 the cabinet cutout dimensions for wall mounted and under the counter installations are shown in figs. 2 and 3, respectively. It is good practice, when oven is installed at the end of a cabinet run, adjacent to a perpendicular wall or cabinet door, to allow at least 1/4" space between the side...

  • Page 3

    Page 3 fig. 2- cabinet cutout - wall mounted installation refer to dimensions for specific ovens on page 4 front view side view floor line f g double oven location of conduit box exposed edge must be a finish-cut d recommended 2" diameter hole (4.5 cm) frame overlap (top) 3/8" (1, 0 cm) cabinet appr...

  • Page 4: Under The Counter Units —

    Page 4 under the counter units — a single oven (sc301, c301, cj301 or cm301) installed under the counter allows for the installation of most thermador gas or electric non-cook'n'vent® model cooktops. (see table 1 for recommended cooktop models.) downdraft units cannot be installed in this configurat...

  • Page 5

    Page 5 fig. 3 - cabinet cutout - 30" single oven under the counter installation side-by-side installation units — the minimum distance required for side by side installation is 2 inches (5, 1 cm) from one vertical edge of the cabinet cutout to the adjacent edge of the next cabinet cutout. Use only t...

  • Page 6

    Page 6 step 3: electrical installation all model ovens on the front cover are dual rated, designed to be connected to either 120/240v ac or 120/ 208v ac, 60 hz, 4 wire, single-phase power supply. The sc301 requires a 20-amp circuit. The c271, c301, cm301, cj301, smw272 and sm272 require a 30-amp cir...

  • Page 7

    Page 7 208v electrical hookup applies to c271, c272, c301, c302, cm301, cm302, cj301 and cj302 models only. Your oven has been preset to be hooked up to 240v. 1. Turn off the oven(s). 2. Open the upper oven door. 3. Press and hold the upper off pad in a double oven or the off pad in a single oven. 4...

  • Page 8

    Step 5: installing the bottom trim (except cj301) install the bottom vent trim and se- cure with (2) screws provided, one at each top end corner of the trim. The sheet metal bottom of the oven should be under the trim, except for the section at the center. To install the screws, open the door. The h...