1. DL manuals
  2. U-Line
  3. Refrigerator
  4. Echelon BI 2015
  5. Installation Manual

U-Line Echelon BI 2015 Installation Manual

Summary of Echelon BI 2015

  • Page 1

    Www.U-lineservice.Com phone (414) 354-0300 • fax (414) 354-7905 service & parts tech lines phone (800) 779-2547 • fax (414) 354-5696 onlineservice@u-line.Com ©2005 u-line corporation 02/2005 bi2015 — ice maker installation guide ™.

  • Page 2

    Bi2015 — ice maker www.U-lineservice.Com 2 02/2005 ™ contents exterior cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 cut-out dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 product dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 door s...

  • Page 3

    Bi2015 — ice maker 02/2005 3 www.U-lineservice.Com ™ general precautions use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: warning shock hazard — electrical grounding required. • keep the unit unplugged throughout ins...

  • Page 4

    Bi2015 — ice maker www.U-lineservice.Com 4 02/2005 ™ after all the protective coating has been removed from the unit/door, clean all stainless steel surfaces with claire stainless steel polish and cleaner or comparable product or a mild detergent and warm water solution and soft cloth. Do not use ab...

  • Page 5

    Bi2015 — ice maker 02/2005 5 www.U-lineservice.Com ™ product dimensions please note that the unit has adjustable feet that can add one additional inch to height during leveling or to match adjacent cabinets (see figure 35 on page 14). Door swing/clearances information black and white units have a ze...

  • Page 6

    Bi2015 — ice maker www.U-lineservice.Com 6 02/2005 ™ 4. Remove the two door closer inserts from the existing bottom hinge and install as shown on the new bottom hinge (see figure 8). 5. Remove existing bottom hinge (3 screws) and remount on opposite side top. Remove hinge screw pin. 6. Remove the pl...

  • Page 7

    Bi2015 — ice maker 02/2005 7 www.U-lineservice.Com ™ side-by-side installation instructions for a complete refreshment center, install your bi2015 ice maker beside a u-line refrigerator, combo, or wine captain model (see figure 11 for typical cut-out). Note that each side-by-side installation will b...

  • Page 8

    Bi2015 — ice maker www.U-lineservice.Com 8 02/2005 ™ 2. Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see figure 13). This may take some force. Do not remove the three screws behind gasket. 3. Remove two outside screws holding d...

  • Page 9

    Bi2015 — ice maker 02/2005 9 www.U-lineservice.Com ™ route notch in top corner of overlay panel as shown (see top and side views). Top of notch is entire depth of panel, front to back. Width: 13/16" depth: 1/8" route notch in backside of top corner of overlay panel (see back and side views). Width: ...

  • Page 10

    Bi2015 — ice maker www.U-lineservice.Com 10 02/2005 ™ 4. Remove the top handle and discard. (this handle will be replaced with the modified handle included in the full overlay door panel kit.) 5. Remove the two screws located on both sides of the lower handle. Remove the handle. 6. Attach the modifi...

  • Page 11

    Bi2015 — ice maker 02/2005 11 www.U-lineservice.Com ™ 5. Remove the existing bottom pivot plate and replace with the full overlay pivot plate (see figure 23). Important door panel and overlay panel must be aligned properly or the door will not operate correctly. Assembling the door 1. Install the as...

  • Page 12

    Bi2015 — ice maker www.U-lineservice.Com 12 02/2005 ™ checking door alignment the unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. Important properly aligned, the door should be 1/8" below the t...

  • Page 13

    Bi2015 — ice maker 02/2005 13 www.U-lineservice.Com ™ caution plumbing installation must observe all state and local codes. All water connections must be made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. Warning to...

  • Page 14

    Bi2015 — ice maker www.U-lineservice.Com 14 02/2005 ™ electrical specifications caution electrical installation must observe all state and local codes. This unit requires connection to a grounded (three- prong), polarized receptacle that has been placed by a qualified electrician. The unit requires ...

  • Page 15

    Bi2015 — ice maker 02/2005 15 www.U-lineservice.Com ™ installation of the bi2015 1. Open the water supply valve in the main water source. 2. Make sure the on/off switch is in the off position (see figure 36). 3. Plug in the power cord. 4. Gently push the unit into position. Be careful not to kink th...

  • Page 16

    Bi2015 — ice maker www.U-lineservice.Com 16 02/2005 ™ start-up troubleshooting problem q: unit does not appear to turn on when switch is set to on. Solution a: make sure unit is plugged in and outlet has power (circuit breaker has not tripped). Remember that the ice maker mechanism will not fill the...

  • Page 17

    ™ ©2005 u-line corporation publication no. 30056e 02/2005 rev. A u-line corporation, located in milwaukee, wi, is a family operated manufacturer of built-in undercounter icemakers, combo ® icemaker/refrigerators, wine captain ® wine storage units, refrigerators, refrigerated drawers and refrigerator...