Summary of Echelon BI-2115

  • Page 1

    Use and care guide bi2115 ice maker model: bi2115 ulin_016357_30097.Fm page 1 tuesday, march 14, 2006 2:30 pm.

  • Page 2

    2 bi2115 congratulations on your purchase of a u-line refrigeration product. A pioneer in the field for more than 40 years, u-line corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-line dedicates 100% of its research and...

  • Page 3

    Bi2115 3 introduction ...............................................................................................................................2 warranty registration .......................................................................................................2 please record your mod...

  • Page 4

    4 bi2115 this page intentionally left blank.

  • Page 5

    Bi2115 5 important important please read all instructions completely before attempting to install, operate, or service your unit. • proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. An installation guide f...

  • Page 6

    6 bi2115 Échelon model bi2115 ice maker the bi2115 ice maker will produce and store up to 25 lbs (11.3 kg) of ice per day. It conserves on water, using only 2-3/4 gallons (10.4 l) to produce approximately 22 lbs (10 kg) of ice, and features a clear removable ice bucket. Manual defrosting will be occ...

  • Page 7

    Bi2115 7 figure 3 2. Turn the adjusting screw (figure 3) using a flat tip screwdriver in a small increment clockwise for a colder setting (slower ice production) or counterclockwise for a warmer setting (faster ice production). 3. Replace the front grille (two screws). Ice maker when the ice bucket ...

  • Page 8

    8 bi2115 outdoor, marine and rv usage some u-line models are designed to operate in outdoor, marine and rv environments. For best performance, keep the unit out of direct sunlight. • if the unit will be shut off for five days or more, prop door open to allow for air circulation and prevent mold and ...

  • Page 9

    Bi2115 9 general cleaning exterior cleaning (as required) black and white models: • surfaces may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spott...

  • Page 10

    10 bi2115 to defrost: 1. Turn unit off. 2. Remove ice bucket and discard ice. 3. Place a towel or other absorbent material on bottom of unit (figure 5, 1). 4. If you would like, place warm water inside ice bucket. Then place ice bucket back into unit and close door. 5. After approximately one hour, ...

  • Page 11

    Bi2115 11 7. Open the water main supply valve and check for leakage at the water hose connection. Ensure that the water supply line is not kinked. 8. Reconnect power to the unit before re-installing. Ice cube thickness adjustment interval - as required on ice maker equipped models, the cube size may...

  • Page 12

    12 bi2115 door alignment check and adjustment important important when properly aligned: • the door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top. • the door gasket will be firmly in contact with the perimeter of the cabinet ...

  • Page 13

    Bi2115 13 door reversal figure 16 all u-line black or white units may be left- or right-hand opening. Stainless steel unit doors cannot be reversed. The doors are easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used on the bottom of the other side an...

  • Page 14

    14 bi2115 5. Remove the two door closer inserts (figure 20, 1) from the existing bottom hinge and install as shown on the new bottom hinge (figure 19, 1). 6. Remove existing bottom hinge (three screws) and remount on opposite side top. Remove hinge screw pin. 7. Remove the plastic hole plug from the...

  • Page 15

    Bi2115 15 troubleshooting guide danger electrocution hazard never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - what to check when problems occur: problem possible cause remedy the unit frosts up. High ambient temperatur...

  • Page 16

    16 bi2115 this page intentionally left blank.

  • Page 17

    Bi2115 17 this page intentionally left blank.

  • Page 18

    18 bi2115 this page intentionally left blank.

  • Page 19

    Bi2115 19 u-line corporation limited warranty u-line corporation warrants each u-line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot ...

  • Page 20

    For general inquiries: p.O. Box 245040 milwaukee, wisconsin 53224-9540 u.S.A. Phone (800) 779-2547 fax (414) 354-5696 www.U-line.Com for service and parts assistance: phone (800) 779-2547 (414) 354-0300 fax (414) 354-5696 email: onlineservice@u-line.Com www.U-lineservice.Com e-mail: onlineparts@u-li...