U-Line Echelon Wine Captain 2275ZWCOL Installation Manual - page 5
03/2008
5
www.U-LineService.com
2275 Dual Zone WC Model
POWER SUPPLY
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A circuit (normal household current). See
Electrical Specifications.
ENVIRONMENTAL REQUIREMENTS
Many U-Line models are designed to operate in harsh
outdoor/marine environments. Special considerations
include the following:
• The units are designed to operate between 50°F (10°C)
and 110°F (40°C). High ambient temperatures (110°F
[40°C] or higher) may reduce the unit’s ability to reach
low temperatures.
• For best performance, keep the unit out of direct
sunlight and away from heat generating equipment.
• In climates where high humidity and dew points are
present, condensation may appear on outside surfaces.
This is considered normal. The condensation will
disappear when the humidity drops.
• U-Line does not recommend installation of glass front
models (Wine Captain
®
wine storage models and
Beverage Centers) as well as the Combo Drawer model
(Refrigerator/Freezer/Ice Maker) outdoors, or in
tropical climates where high humidity and dew point
are present on a regular basis, unless air-conditioning
(typical 72°F, 75%RH) will be used.
All U-Line units (except Stainless Steel models) may be
left- or right-hand opening. The door opening is easily
reversed by moving the hinge hardware to the opposite
side. The top hinge hardware will be used on the bottom
of the other side and the bottom hinge hardware will be
used on the top of the other side (see Figure 4).
To reverse the door:
1. Using a Phllips screwdriver, remove top hinge screw
pin from door (Figure 5). Remove door by tilting
forward and lifting off bottom hinge pin.
Figure 5
2. Remove metal hinge plugs (3 each, top and bottom)
from new hinge location. Do not discard (Figure 6).
Figure 6
3. Remove top hinge (3 screws), reinstall hinge screw pin,
and remount on opposite side BOTTOM (Figure 7).
Figure 7
4 Other Site Requirements
5 Reversing The Door
ULIN_0015_A
Hinge plugs
hinge screw
pin
hinge screws
ULIN_0003_A