U-Line Echelon Wine Captain 2275ZWCOL Installation Manual - page 6
www.U-LineService.com
6
03/2008
2275 Dual Zone WC Model
4. Remove the two door closer inserts from the existing
bottom hinge and install as shown on the new bottom
hinge (Figure 8).
Figure 8
5. Remove existing bottom hinge (3 screws) and remount
on opposite side TOP. Remove hinge screw pin.
6. Remove the plastic hole plug from the top of the door
to allow the pivot pin to be inserted in the new
location. Install the plug into the vacated hole on the
opposite side.
7. With bottom of door facing up, remove pivot plate (2
screws), flip over, and remount on opposite side of door
(Figure 9). Be sure angled side of plate faces center.
Figure 9
8. Holding door upright with top of door tilted forward,
place hole of door pivot plate on bottom hinge screw
pin (Figure 10).
9. Tilt top of door into position in top hinge and install top
hinge screw pin.
10. Install metal hinge plugs removed in step 2 in old hinge
holes (3 each, top and bottom).
Figure 10
For a complete refreshment center, install your Dual-Zone
unit beside a U-Line Refrigerator, Ice Maker or Combo
Model (see Figure 11 for typical cut-out).
Note: Each side-by-side installation will be different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit’s Installation Guide.
For example:
Placing a 2275 Dual-Zone Wine Captain
®
next to a
2115 series unit would require a cut-out width of:
24-3/16" + 15-3/16" = 39-3/8"
Placing a 2275 Dual-Zone Wine Captain
®
next to a
2175 series unit would require a cut-out width of:
24-3/16" + 24-3/16" = 48-3/8"
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s
Electrical Specifications.
Figure 11
The U-Line Dual-Zone units are equipped with wood
trimmed racks that are coated at the factory with a clear
vinyl sealer, which will adequately protect the wood in
normal usage. A final finish coat was not applied so that
the wood trim could be stained to match dècor or overlay
frame. The trim on the racks may be coated with a final
finish or stained.
2275ZWCOL Models are designed for, and require
installation of, an Overlay Frame. If none of these
door closer inserts
ULIN_0274_A
bottom hinge screw pin
door pivot plate
6 Side-By-Side Installation
Instructions
7 Prepare Racks and Door Frame
7"
4"
34-1/4"
to
35-1/8"
1/4" Space
Between
Appliances
23-1/4"
Typical Side-By-Side Cut-Out