Www.U-lineservice.Com phone (414) 354-0300 • fax (414) 354-7905 service & parts tech lines phone (800) 779-2547 • fax (414) 354-5696 onlineservice@u-line.Com ©2005 u-line corporation 02/2005 sp18 ice maker for marine or recreational vehicle use installation guide.
Www.U-lineservice.Com 2 02/2005 sp18 ice maker contents exterior cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 cut-out dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 product dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 door swing/c...
02/2005 3 www.U-lineservice.Com sp18 ice maker general precautions use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: warning shock hazard — electrical grounding required. • keep the unit unplugged throughout installat...
Www.U-lineservice.Com 4 02/2005 sp18 ice maker your u-line product has been designed for built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must not be obstructed and clearance is required for water and electrical c...
02/2005 5 www.U-lineservice.Com sp18 ice maker reversing the door all units may be left- or right-hand opening. To reverse the door: 1. Remove travel pin from cabinet (two screws). See figure 4. Slide assembly through flange and set aside to be used later. 2. Remove top hinge from cabinet (three scr...
Www.U-lineservice.Com 6 02/2005 sp18 ice maker 9. Gently slide upper hinge through flange and fasten upper hinge to unit (three screws). Partially tighten screws. See figure 11. 10. Place door on lower hinge pin. 11. Align door pivot hole with pivot hole in upper hinge and insert pivot screw into up...
02/2005 7 www.U-lineservice.Com sp18 ice maker checking door alignment the unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment. Important properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way a...
Www.U-lineservice.Com 8 02/2005 sp18 ice maker 2. Locate the compression fitting and ferrule packed with the unit. Slide the compression fitting and ferrule over the 1/4-inch od water supply line. Do not use thread sealing compound or tape. Using two wrenches, tighten the compression fitting on the ...
02/2005 9 www.U-lineservice.Com sp18 ice maker leveling information important it is extremely important that the unit sits on a level surface, as it does not have feet levelers. If it is not level, the ice mold will not fill evenly. Use a level to check the levelness of the unit from front to back a...
Www.U-lineservice.Com 10 02/2005 sp18 ice maker initial start-up the on/off switch is located on the front grille. Ensure that the switch is turned on. No setting adjustments should be necessary at this time. For information about adjusting the temperature control, see the user manual. As soon as th...
©2005 u-line corporation publication no. 30073e 02/2005 u-line corporation, located in milwaukee, wi, is a family operated manufacturer of built-in undercounter icemakers, combo ® icemaker/refrigerators, wine captain ® wine storage units, refrigerators, refrigerated drawers and refrigerator/freezers...
