U-Line U-3018CLROL-00 Install Manual - page 15
Installation Guide
13
Ice Machines
compression nut and ferrule onto the copper tubing as shown
below.
9. Feed the complete assembly into the garden fitting and tighten.
Attach to the water valve located in the front of the unit.
10. Gray hooks are located in the front of the condenser and behind
the condenser. Use these to secure the copper tubing to be within
two inches of the top of the unit.
11. Turn on water and check for leaks.
12. Re-attach back panel and front panel.
U-Line Water Hookup Kit Connection
CAUTION
!
Turn off water supply and disconnect electrical supply to
unit prior to attempting installation.
1. Turn off water supply and disconnect electrical supply to unit
prior to attempting installation.
2. Remove back panel of unit.
3. Remove front panel of unit. See image below for location of front
panel screws.
4. Take one end of the braided line and feed it through the front of
the unit between the condenser and the right side of the unit. This
tubing should be within two inches of the top of the compartment.
5. Take the end of the braided line and put the line through the hole
in the back panel.
6. Locate the desired cold water supply location.
7. Attach the end of the braided line to this cold water supply
location. Leave approximentely 4’ of water line to be coiled behind
the applicance.
8. Attach the garden hose connection from the kit to the front of the
unit.
9. Attach the front of the braided line to this garden hose connection.
Ensure that there is still approximately 4’ of water line is coiled
behind the appliance. The water line should be looped in 2 coils.
This will allow the line to flex when removing the unit for cleaning
and servicing. Do not kink or pinch the coiled line.
10. Turn on water supply and check for leaks.
11. Re-attach back panel and front panel.
9/16" Wrench
1/4" Copper Water
Supply Line
7/16" Wrench
From Water Supply
to Ice Maker
Compression Nut
Ferrule
Front Panel
Remove screws
(one on each side)
to access behind
the front panel
Water inlet line
should be within 2
inches of the top of
the compartment