VADDIO CEILINGVIEW HD CCU Installation And User Manual - page 11
CeilingVIEW HD
Vaddio CeilingVIEW HD CCU Installation and User Guide - Document 341-768 Rev. A
Page 11 of 16
•
Quick-Connect CCU Interface (QCCU)
Connectors
Power Connector: 36VDC 5.5mm OD x 2.5mm ID
Power RJ-45: Not applicable with CeilingVIEW CCU
Control In RJ-45: Accepts RS-232 from ProductionVIEW or other non-daisy-chain control systems
Control Out RJ-45: Passes RS-232 and Sync video feed to camera EZIM
Tally: 2-Pin Phoenix type spring cage connector
Video Inputs: Not applicable with CeilingVIEW CCU
Video Outputs: Not applicable with CeilingVIEW CCU
Video RJ-45: Not applicable with CeilingVIEW CCU
Camera Feature Dip
Switch
For Future Functionality – Leave all switches in the down position
Video Adjustments
Unused on the Quick-Connect CCU – Make adjustments on the Quick-Connect CV HD/SD
Power Supply
36 VDC, 2.08 Amp
Dimensions
1-RU Rack Mount - 1.75” H x 19” W x 6” D (4.45 cm x 4.26 cm x 15.24 cm)
CeilingVIEW HD CCU
Part Numbers
999-3009-000 (North America)
999-3009-001 (International)
Image Sensor
Sony 1/3-type HD CMOS
Total Number of Pixels
Approx. 2M pixels
Aspect Ratio
HD: 16:9
SD: 4:3 or 16:9
Angle of view (H)
Approx. 50°(wide end) to Approx. 5.4°(tele end)
Minimum illumination
12 LUX Typical (F1.8, 50IRE)
Minimum Object Distance
10mm (wide) to 800mm (tele)
Optical Zoom
10 x zoom, f=5.1mm (wide end) to 51 (tele end) F1.8 to F2.1
Digital Zoom
12X (120X Total Zoom)
Signal system
HD: (16:9) : 1080/59.94i, 1080/50i, 720/59.94p, 720/50p,
SD: NTSC (crop/squeeze), PAL (crop/squeeze)
Focus System
Full Auto, Manual (near, far)
S/N Ratio
More than 50 dB
Video Output HD
HD: Analog Component Y/Pb/Pr
Video Output SD
VBS:1.0 Vp-p (Sync Negative) & Y/C Output
Sync System
Internal Sync
Camera Control
•
RS-232 (VISCA™, baud rate: 9.6 Kb/s, 19.2 Kb/s, 38.4 Kb/s, 1-stop bit)
•
IR - Responds to Vaddio IR Remote (full functionality), Polycom and TANDBERG
IR ZOOM IN and ZOOM OUT commands automatically.
•
With dip switch control (#2 UP), Polycom and TANDBERG “TILT DOWN”
command can activate the Laser Pointer “MOMENTARY ON” command for
document positioning – SET DIP SWITCHES ON CAMERA ENCLOSURE ONLY
Effects
Freeze, B/W, Negative Art
•
Camera Enclosure
Components
Camera Enclosure, White Trim Ring, Mounting Rails and Mounting Hardware
Connectors
One (1) RJ-45 for Video and Power – Connect to Quick-Connect CV HD/SD
One (1) RJ-45 for RS-232 – Connect to Quick-Connect CCU
Camera Enclosure Dimensions
4.85” x 5.75” x 5.75” (H x W x D),
Camera Enclosure Weight
2.4lbs
•
Quick-Connect CV HD/SD
Connectors
One (1) RJ-45 for Video and Power
3-BNC: Analog Component Y/Pb/Pr Outputs or SD (Y/C and composite) Outputs
Note: CeilingVIEW HD can output HD or SD Video, but not both concurrently
5.5mm OD x 2.5 ID Power Connector
Controls
Y-Gain Adjustment
Distance Adjustment (for longer CAT-5 cable runs)
Max CAT-5 Cable Distance
400’/121.92m
between Quick-Connect CV HD/SD and Camera Enclosure
Quick-Connect CV HD/SD Dimensions
1.75” x 5.5” x 3.0” (3.75” with BNC connectors) (H x W x D) 1/3-Rack Width
Quick-Connect CV HD/SD Weight
1.0lbs
Power Supply
24VDC, 2A
Accessories
999-6000-002 Rack Mount Adapter Panel for 1/3-Rack Quick-Connect Interface