VADDIO CEILINGVIEW HD CCU Installation And User Manual - page 6
CeilingVIEW HD
Vaddio CeilingVIEW HD CCU Installation and User Guide - Document 341-768 Rev. A
Page 6 of 16
Dip Switch Settings
Set the dipswitches to the desired signal/function and then apply power to the system. To make any
changes, remove power from the system, make the change and re-apply power to the system.
Description / Dip Switch 1
2
3
4
5
6
1080i/59.94 Camera Output Resolution
*
*
DN
DN
DN
DN
1080i/50 Camera Output Resolution
*
*
DN
DN
DN
UP
720p/59.94 Camera Output Resolution
*
*
DN
DN
UP
DN
720p/50 Camera Output Resolution
*
*
DN
DN
UP
UP
SD SQ NTSC (std. def. squeezed)
*
*
DN
UP
DN
DN
SD SQ PAL (std. def. squeezed)
*
*
DN
UP
DN
UP
SD Crop NTSC (std. def. cropped)
*
*
DN
UP
UP
DN
SD Crop PAL (std. def. cropped)
*
*
DN
UP
UP
UP
CeilingVIEW HD CCU Laser Pointer “MOMENTARY ON” will be
activated by the Polycom or TANDBERG IR Remote Controller “TILT
DOWN” command
DN
UP * * * *
CeilingVIEW HD CCU Laser Pointer “MOMENTARY ON” will not be
activated by the Polycom or TANDBERG IR Remote Controller “TILT
DOWN” command
DN
DN * * * *
Disable All Polycom and TANDBERG IR Remote Commands
UP
*
*
*
*
*
* - Position not applicable - Output Resolution is independent from the Laser Pointer.
Figure 6: Vaddio IR Remote
Programming the Remote:
1. Install 3 “AAA” batteries into the remote
2. Press and hold POWER & FREEZE for 5 seconds
Setting Zoom Presets (Vaddio Remote):
1. Zoom the camera lens to the desired position.
2. Press and hold the SET button for one second. The blue LED will blink for approximately 5 seconds.
3. Press button labeled 0 through 5 within the 5 seconds. The Blue LED on camera will stop blinking.
4. To Recall Presets, press on the PRESET buttons labeled 0 thru 5.
Function
Description
POWER
Camera on/off
ZOOM
IN (tele)
OUT (wide)
FOCUS
AUTO:
Auto Focus Mode ON
NEAR:
Manual Focus Near
FAR:
Manual Focus Far
LASER
ON:
On/Off toggle
MOM:
Turns on Laser for five seconds -
Momentary
BRIGHT
UP:
Brightness up
DOWN:
Brightness down
PRESET
Six (6) presets - 0 though 5
SET
Sets Zoom Presets
W/BAL
One Touch White Balance
BKLIGHT
Back Light Compensation
B/W
Black and White Mode (color off)
POS/NEG
Positive/Negative - Art Mode
FREEZE
Freeze Frame/Image Effect