VADDIO Wallview CCU HD-20 HD-SD Installation And User Manual - page 10
WallVIEW CCU HD-20
WallVIEW CCU HD-20 Manual 342-0181 Rev. C
Page 10 of 20
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
Note: When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions
and check for in-wall obstructions where the camera is to be mounted. Pick a mounting location to optimize the
performance of the camera.
The 2 (two) Cat-5e cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the
rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket (see Fig. 1).
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two (2) lower
wall anchors to correctly fasten the Conceal Wall Mount to the wall.
If mounting to drywall with wall anchors, use the four (4) quality wall anchors/screws provided (see Fig. 1). Note:
The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount and tighten the
mounting screws.
Step 2: EZIM CCU Card Installation:
Locate the EZIM CCU Card (see the front page of the manual for a picture of the device). Remove the blank
panel below the connectors on the back of the camera. Slide the EZIM CCU Card into the slot on the back of the
camera until the connector is seated into the camera. Tighten the thumb screws on the EZIM CCU Card.
Note: IR Output - Dip Switch 4: When operating the HD-20 camera with the Quick-Connect CCU, the
IR Output must be set to the OFF position on the back of the camera. If it is not turned off, it will interfere
with proper operation of the PTZ camera.
Step 3:
System Wiring:
Follow the sample wiring diagram on the previous page for connecting the CAT-5 cables to the camera and
Quick-Connect CCU, using a Vaddio ProductionVIEW Precision Camera Controller. Additional diagrams are
available on our website for installation with other equipment.
IMPORTANT NOTE: Check all Cat-5e cables for continuity in advance of final connection.
Plugging the EZ POWER/VIDEO Cat-5e Cable into the wrong RJ-45 may cause damage to the
camera system and void the warranty!
Step 4: Secure the Camera To the CONCEAL Wall Mount Bracket:
After all cables are attached to the camera, place the camera onto the camera mount and insert the two-(1/4”-20)
screws into the camera through the two-screw holes in the bottom of the mount.
Note: Be sure to align each side of the camera evenly to all sides of the CONCEAL Wall Mount Bracket
before final tightening of the mounting screws (see Fig. 2).
Fig. 1: CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Fig. 2: Vaddio HD-20 Camera
aligned and attached to the
CONCEAL Wall Mount Bracket