VADDIO Wallview CCU HD-20 HD-SD Installation And User Manual - page 6
WallVIEW CCU HD-20
WallVIEW CCU HD-20 Manual 342-0181 Rev. C
Page 6 of 20
Quick Connect CCU Rear Panel Connections and Controls (left to right)
Power Supply Input:
36V 2.78 Amp power supply on a 5.5mm OD x 2.5mm ID connector.
Power on RJ-45:
Power is provided on a Cat-5e cable to the EZIM CCU Slot Card. Power is on all 4-pr and is connected to the
36VDC RJ-45 on the EZIM CCU Slot Card.
RS-232 IN on RJ-45:
RS-232 IN from ProductionVIEW or PTZ controller RS-232 port. Daisy Chain control is not supported.
RS-232 OUT / G/L Out on RJ-45:
The RS-232 OUT is connected to the HD-20 RS-232 RJ-45 jack. The HD-20 camera does not support
GENLOCK.
Tally on 2-pin Phoenix type connector:
Contact Closure lights a Vaddio blue LED on front panel allowing indication of which CCU/camera combination is
active in a multi-camera/CCU installation. A tally command will also be sent to the HD-20 camera to illuminate
the red LED on the camera’s base.
G/L Input on BNC-F:
This option is not used with the HD-20 camera.
Camera Feature Switches:
The Quick-Connect CCU has an 8-position dip switch on the rear panel. For the HD-20, all these switches should
be set to the down position.
Y-Gain:
Adjusts Y-Gain and allows the user to fine tune the video signal especially over longer cable lengths. Adjust to
system requirements (100 IRE on waveform analyzer).
Distance:
Distance adjustments for Cat-5e cable (<100’, 200’, 300’, 400’+) which, equalizes the length of the twisted pairs
for improved video performance.
Video Outputs:
HD YPbPr signals can be transmitted from the EZIM CCU. Note: Y/C (S-Video) and composite video is not
available on the HD-20 HD camera.
Relevant Connector Labels and Supported Video Signals
Y:
Y of YPbPr on BNC-F connector
PB:
Pb of YPbPr on BNC-F connector
PR:
Pr of YPbPr on BNC-F connector
Video RJ-45
This jack is connected to the HD-20 EZIM CCU Slot Card Video RJ-45 Jack to return HD video to the CCU.
EZIM CCU Slot Card
①
①
②
②