Valet SmartCentre Installation Manual - 1 Single Doorbell/camera:
1 Single Doorbell/Camera:
2.1 Please take a moment to select the most suitable Doorbell/Camera position.
2.2 Please consider both daytime, night time and likely weather condition impact. Direct sunlight on the
camera and direct contact with rain should be avoided. Your Valet Dealer can assist you with
Weathershields for exposed positions.
2.3 Determine Camera Position: Please ensure you run cable through the camera mounting plate or back
box if fi tted. ( Average Height 1.5 to 1.6 metres ).
2.4 Both Surface Mount and Flush Mount Doorbell/Cameras require fi tting of each cameras mounting plate
or back box. Please check locating screws in top and bottom of Cameras.
2.5 The fl ush mount Camera requires a hole 75mm D x 50mm W at the desired location for the rear
camera housing and lens position adjuster. The Surface Mount Doorbell/Camera has an internal back
box that requires mounting on the wall.
2.6 Please ensure you run the cable through the mounting plate or back box
2.7 Connect your cable to the Doorbell/Camera following the wiring diagram .
2.8 Affi x the Doorbell/Camera onto its mounting plate or back box and secure with locator screws supplied.
Power up Intercom system when all connections are complete.
Valet SmartCentre
Video Intercom System
14