Valet SmartCentre Installation Manual - Valet Smartcentre
Valet SmartCentre
Video Intercom System
System Operating Guide
Please Note: The system must be set for the correct combination of monitors.
Each monitor is set as default to “MAIN”. Using system settings, set-up multiple
monitor systems as one “MAIN” monitor and the additional monitors as “SUB”.
You must defi ne a primary Monitor as “MAIN” and additional Monitors as “SUB”.
When adjusting the set up of multiple monitor systems please set up ONE monitor
at a time.
If two monitors are adjusted at the same time they may shut down for a short
period and go into recovery mode, from which the setting may be lost and will need
to be re-entered.
If power is lost or switched off, all system settings will be saved in memory. By
entering set-up mode (press and hold Button 6) the power out time will remain in
the display. However, the time and date clock will still run in the background.
Exit set-up mode and re-enter set-up mode and the current time will be displayed.
1. System Settings
At standby mode, press and hold “Photo Button” for 2 seconds to get into the set-up
• 1
st
line: Day/Mth/Yr & Time for system
• 2
nd
line: Chime DurationTime
• 3
rd
line: Chime Volume (High/Low/Mute)
• 4
th
line: Talk Volume (High/Low)
• 5
th
line: CharacterAdd:Enable/Disable=
“DOOR1/DOOR2” on monitor screen )
• 6
th
line: Main/Sub Multiple Monitor set up.
• HOLD button 6 on MAIN or SUB for 3 secs
• 7
th
line: Photo Image Enable (optional)
SYSTEM SETTINGS
TIME 10-20-5 12:50:27
CHIME TIME 30S
CHIME VOL HIGH
TALK VOL HIGH
CHAR ADD ENABLE
INTERCOM SUB
TAKE PHOTO ENABLE
16