Valor 805 alsace Installer And Owner Manual - Installation
Spacers and Wall Kits:
The heater is of a slim design and should suit most fireplace openings and fire
surrounds, however there may be some applications that require the need for either a
spacer or flat wall kit.
These optional kits are obtainable either from the your heater supplier or direct from
Valor Sales.
The kits are:
For 60mm (2.1/2") Surround Rebate - 20mm Spacer Kit No. 05801R1
For Flat Wall (no recess) - 75mm Wall Kit No. 05801T1
Installation
The heater must be fixed into position to prevent it from being tipped over.
Screw fixing and wire fixing options are available. The parts required for both
fixing options are included with all appliances.
The heater must not be located under a fixed electrical socket. The socket must
always be accessible in order to disconnect the heater from the electrical supply for
maintenance or when replacing a lamp.
Important! This heater must be earthed. The heater is supplied with a 3 pin 13A
fused re-wireable plug with 1mm². 3 core mains cable,
L = Brown
N = Blue E= Green/Yellow
The mains supply cable must be safely routed from the heater to an electrical
socket. Provision is made for left/right or rear cable entry. Using one of the three cable
guides at the base of the heater. To relocate, open the appropriate latch on the cable
guide and refit the mains cable into the required position. If the mains cable is
damaged, to avoid a hazard it must be replaced by a Valor authorised service agent, or a
similarly qualified person.
The heater body should be fixed in position before the front surround is finally
fitted.
Please study the illustrations carefully to
avoid damage to the heater.
Front Removal - (Alsace model only)
Remove the tape holding the lower front &
coal support to the heater base.
Carefully lift the lower front & coal
support up to release it from the keyholes in
the surround and then pull forward and clear.
Page 5
INSTALLER AND OWNER GUIDE
Figure 1.