Valor 805 alsace Installer And Owner Manual - page 7
instructions).
Method D - With optional 75mm Wall Spacer Kit
The wall kit should be securely fixed to the wall using the
screws provided. The heater must then be fixed to the wall
kit (see kit instruction). If fixing through marble, ensure that
both rawlplug and screw pass freely through the marble.
Secondary Screw fixing
If necessary, the heater can be additionally secured by
screws through the side flanges - see figure 6.
Assembly of Front
Carefully lift the front surround. Hook the front surround
onto the retaining plates on the heater body and
lower the front surround down - See figure 7.
Fix the front surround to the heater body with
the two screws previously removed.
Final Assembly
Alsace model: Refit the lower front & coal
support by locating the four screw heads at the back
into the keyholes in the surround and then lowering
the support.
Tudor model: Fit the lower firefront casting & coal support by locating the two
screw heads at the back into the keyholes in the surround and then lowering.
Open the polythene bag containing the loose coals and place them on top of the coal
support to give the most pleasing effect. It is not necessary to use all the coals supplied.
Operating the Heater
Never cover the heater. There is a risk of fire if it is covered.
The heater is operated by three switches, located below the canopy.
Switch 1 =
O
Main On - Off
In the On position only the fuel effect light operates
Switch 2 =
I
1kW fan heat setting and fuel effect
Switch 3 =
II
2kW fan heat setting and fuel effect
Page 7
INSTALLER AND OWNER GUIDE
Figure 7.
Figure 6.