Valor 805 alsace Installer And Owner Manual - page 6
See figure 1.
Both models
Carefully remove the front surround by removing the two
trim fixing screws and lifting upwards and forward - See
figure 2.
Keep the lower front, front surround and screws in a safe
place when installing the fire.
Offer the heater body to the fireplace opening to ensure
that it will fit before continuing to install.
Appliance Fixing
Method A - Screw Fix
There are two slots in the top flange - See figure 3.
Mark the fixing position through the slots. Remove the
heater.
Drill a hole with a No.12 drill bit at each marked
position.
Insert the wall plugs provided.
Reposition the heater body and screw through the slots
to provide a secure fixing.
Method B - Wire Fix
A steel wire and eyebolt are supplied to attach the
heater to the back of the fireplace opening.
Mark the position for the eyebolt at the back of the
fireplace opening equal to the centre line of the heater and at
a height of 533 - 560mm. Drill, plug and screw in the eyebolt
- See figure 4.
Thread one end of the steel wire through two holes in the
top flange, passing the wire through the eyebolt and out
through one of the opposite holes on the top flange - See
figure 5.
Place the heater in the fireplace opening, then by gently
pulling the steel wire, gather up the excess until the heater
is firm. Thread the wire back through the remaining hole to
lock the wire and heater in place - See figure 5.
Method C - With optional 20mm Wall Spacer
The spacer should be fixed to the fireplace opening or
surround using the screws provided. The heater must then
be fixed to the spacer using the screws provided. (See kit
Page 6
INSTALLER AND OWNER GUIDE
Figure 4.
Figure 5.
Figure 2.
Figure 3.