Valor Fires 829 Installer And Owner Manual - 4. Using The Heater
4. USING THE HEATER
Important Safety.
Never cover the heater or obstruct the openings at the base of the heater, this
could cause overheating and consequent risk of fire.
What are the three switches for?
The heater is operated by three switches located below the hood on the right hand
side of the heater.
Switch 1 =
O
Main On - Off
In the On position only the fuel effect operates
Switch 2 =
I
1kW fan heat setting and fuel effect
Switch 3 =
II
2kW fan heat setting and fuel effect
The switches are mechanically interlocked, so when switch 1 is turned off, all
switches turn off.
5. CLEANING AND MAINTAINING THE HEATER
How do I Clean my heater?
The heater fascia, spacer frame and glass parts need only to be wiped clean with a
dry soft cloth, do not use polishes or abrasive materials.
I have a problem with my heater!
Important Safety
Before undertaking maintenance or replacing the lamp(s) always disconnect the
heater from the electricity supply by removing the 3 pin plug and allowing the
heater to cool.
1. My heater is on but there is no light or the light appears brighter on one
side of the heater.
This is possibly a lamp failure. Remove the lamp(s) as follows and check it / them in a
table lamp that is known to work. If it / they do not work in the table lamp then replace
as below.
The lamps fitted to this heater are standard clear 40W max. E14 candle lamps, but
due to the indeterminate life span and ease of replacement, they are specifically
excluded from the guarantee.
Page 15
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.