Valor Fires 829 Installer And Owner Manual - 3. Fitting The Heater
3. FITTING THE HEATER
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in
doubt, seek help from a competent person.
Before continuing with the installation of this heater, please read and complete
the information on the last page of the guide.
Do I need any tools?
1. Depending upon the chosen method of installation you may need the following
screwdrivers: -
1 off Pozidrive / Phillips / cross head. This should have a number 2 size tip.
1 off Flat end.
2. If drilling into brickwork you will need a power drill (preferably with hammer action)
and appropriate size drill bit for the wall plugs supplied.
Where can I fit the heater?
There should be at least 50mm (2 inches) clearance between the top of the fascia
and anything such as a shelf, fireplace surround or mantel etc. This will allow the
fascia to be lifted off or removed during servicing. To check this gently place the
fascia against the surface to which it is to be fixed. Measure the distance from the top
of the fascia.
Chic, Envy, Mirage and Serenity models.
The heater can be fitted into fireplaces or surrounds where the following dimensions
are available.
Width
390mm - 450 mm (15.35 inches - 17.72 inches)
Height
555mm - 590 mm (21.9 inches - 23.2 inches)
Depth
At least 75mm (At least 3 inches)
The heater can also be fitted against a flat wall. A spacer frame is supplied with the
heater.
Twilight model.
The heater cannot be fitted into fireplaces / fireplace openings. It is intended for
installation to a flat wall. A spacer frame is supplied with the heater.
Page 5
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.