Valor Fires 829 Installer And Owner Manual - page 9
8. Thread the other end of the wire through the
remaining small hole on the left hand side of the
heater. Continue to push the wire through this hole
until there is only a small loop of wire at the front
of the heater (See figure 6 - item 3).
9. At the back of the heater there will be a long
piece and a short piece of wire coming through the
two holes. Hold the short piece and give the long
piece a gentle tug. This will secure the steel wire.
Take the long piece and thread this through the
eyescrew in the back of the fireplace opening (See
figure 6 - item 4).
10. From the back of the heater thread
the long piece of steel wire through the
outer small hole on the right hand side
of the heater (See figure 6 - item 5).
11. Locate the heater in the fireplace
opening, then from the front of the
heater, gently pull the steel wire on the
right hand side to gather up the excess
until the heater is secure. Thread the
wire through the remaining small hole
to lock the wire and heater in place
(See figure 6 - item 6).
Method C - Screw fixing to a flat
wall.
If the heater is to be mounted on to a
plasterboard wall that has a wooden
frame behind it then the integrity and
ability of the wall to carry the weight of
the appliance must be confirmed. It is
important that any vapour control
barrier is not damaged, and that the
structural members of the house are
not damaged.
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 6. Steel wire fixing
Figure 5. Eyescrew position.