Valor Fires 829 Installer And Owner Manual - Important Electrical Safety
Important Electrical Safety
The heater must not be located in front of or under an electrical socket, the socket
must always be accessible in order to disconnect the heater from the electrical supply
for maintenance and cleaning.
Important! This heater must be earthed.
The heater is supplied with a 3 pin 13 Amp fused re-wireable plug with 1mm² 3
core cable.
The wires in the cable are coloured in accordance with the following code: -
Live = Brown
Neutral = Blue
Earth = Green /Yellow
The electric supply must be safely routed from
the heater to an electrical socket.
Moving the Cable
At the base of the heater you will find the electric
cable which runs through a rectangular plastic
cable guide. The cable can be moved to the
opposite side if required. To do this, please see
below:
1. To open the cable guides push and lift the tab on
the bottom of them and the cable guides will open
(See figure 1- Item 2).
2. Place the cable into the opposite guide and
close the bases.
If the electric cable is damaged, to avoid a hazard
it must be replaced by a Valor Fires authorised
service agent, or similarly qualified person.
All external wiring between the heater and the
electrical supply shall comply with current IEE
regulations. Extension leads should not be
used.
Fascia support brackets.
As supplied the fascia support brackets may be
flat against the heater body. Using a suitable
tool or gloved hand, bend the brackets as in
figure 2.
Page 6
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 2. Fascia support brackets
Figure 1. Moving the cable.
Item 1
Item 2