Value Hobby Apollo DLG Instruction Manual - page 5
of
12
www.valuehobby.com/apollo-dlg.html
5
Section 1: Horizontal Tail Installation
Step1. Locate the horizontal tail wing.(The
measurement shows the location of the mounting
block).
Step2. Remove the covering for the tail boom
mounting block on the horizontal stabilizer.
Step3. Mix some epoxy, and glue the mounting block
onto the stabilizer.
Step4. Place the tail boom on the horizontal tail and
adjust tail boom to make the distance of AB is 400mm
(15.7in).
Step5. Apply some epoxy to glue the tail boom to the
mounting block. (Adjust the horizontal tail to make it
parallel to the wing).
Step6. Use a clamp to hold the tail boom and block
until the epoxy cures. (Clamp sold separately.)