Value Hobby Apollo DLG Instruction Manual - page 7
www.valuehobby.com/apollo-dlg.html
7
Section 3: Elevator and Rudder Servo
and Linkage Installation
Step1. Install two servos on the servo mounts.
Step2. Thread the 790mm (31.1in) pushrod wire into
the tail boom. The z-bend will be towards the tail.
Step3. Install the servo arm with pushrod connector
in the servo. Center the servo arm electronically and
slide the pushrod wire into the connector.
Step4. Thread the pushrod wire into the clevis and
tighten the bolt.
Connect the clevis to the control horn.
Position the control horn on the rudder, the pushrod
wire will be aligned with the tail boom, and drill the
mounting holes for the bolts.
Step5. Use three M2*10mm (.4in) bolts to secure the
control horn to the rudder.
Step6. Center the control surface and tighten the
screw on the pushrod connector.