Value Hobby Apollo DLG Instruction Manual - page 6
of
12
www.valuehobby.com/apollo-dlg.html
6
Section 2: Vertical Tail Installation
Step1. Mark on the vertical fin where 70mm (2.8in)
from the left edge of the vertical tail is.
Step2. Insert the vertical tail into the tail boom and
adjust the vertical tail to make the left edge of tail
boom is aligned with the marked line.
Use a felt-tipped pen to trace the outline of the tail
boom onto the vertical stabilizer.
Step3. Cut and trim the coverings inside the lines
drawn in the pervious step, and remove it.
Step4. Use the CA to glue the vertical tail to the tail
boom. (Adjust to make the vertical tail perpendicular
to the wing).
Note: As shown, when finishing the installation. A=A1,
B=B1, C=C1