Vanco D2.1 User Manual - Operation
13
Operation
EQ
EQ FLAT - Press to cancel active EQ and return all EQ settings to neutral (flat).
EQ 1-4 - Press to adjust the tonal balance of the audio output to suit different audio
content...whatever sounds good to you is the right setting!!!
NOTE: EQ 1-3 are factory presets. EQ 4 is configurable with Taylor App.
NIGHT MODE- Press once to turn Night Mode ON (Night Mode maintains relative dynamics of
audio content at low listening levels.) Press again to turn Night Mode OFF.
SOURCE SELECT
IN 1 - Press to select the source connected to the Line L&R jacks on the D2.1.
IN 2 - Press to select the source connected to the Digital Optical jack on the D2.1.
IN 3 - Press this button to select the Beale Street Audio DBT-Taylor Programming Module
connected to the Receiver In Port on the D2.1.
BLUETOOTH
OK...so you’re one of the really smart people who also purchased the Beale Street Audio DBT-
Taylor Programming Module. This device will not only allow you to stream your favorite audio
content via Bluetooth from almost any current Bluetooth device to the D2.1, but it will also
allow IR control of compatible Bluetooth devices using either the D2.1 IR Remote or other
properly programmed IR remote control.
NOTE: Bluetooth sources require Bluetooth Profiles: A2DP for Bluetooth Audio Streaming;
AVRCP for IR control of compatible Android or iOS tablets.
PAIRING A BLUETOOTH DEVICE
With the DBT-Taylor Module connected to the D2.1, open the Bluetooth Menu on the
device to be paired. Select Beale BT from the list. Done...Really...That’s it...Go ahead...play
something...pretty cool huh?
BLUETOOTH TRANSPORT FUNCTIONS
BLUETOOTH PLAY/PAUSE - Toggle Play/Pause when controlling a Bluetooth device paired
to a Beale Street Audio DBT-Taylor Module connected to the D2.1 RJ45 Receiver IN jack.
On the D2.1 IR Remote, press once to Pause Bluetooth device. Press again to Play.
BLUETOOTH SKIP FORWARD/BACK - On the D2.1 IR Remote, press I
◄
to skip to the
previous track when controlling a Bluetooth device paired to a Beale Street Audio DBT-
Taylor Module connected to the D2.1 RJ45 Receiver IN jack. Press
►
I to skip to the next
track.
BLUETOOTH SCAN FORWARD/REVERSE - On the D2.1 IR Remote, press
◄◄
to reverse
scan to the current track when controlling a Bluetooth device paired to a Beale Street
Audio DBT-Taylor Module connected to the D2.1 RJ45 Receiver IN jack. Press
►►
to
forward scan the current track.