Vanco D2.1 User Manual - D2.1 Inputs & Outputs
6
D2.1 Inputs & Outputs
These connectors connect things to the D2.1...some actually do some other stuff too...
100-240V-50/60Hz 2.5A
STATUS
RECEIVER
IN
LINE IN
L
R
SUB OUT
OPTICAL IN
L- L+ R- R+
USB
1
3
4
5
6
7
8
9
2
1. AC POWER TERMINAL (100-240V-50/60Hz 2.5A) - Universal power connector.
Automatically selects AC power mode (110VAC/220VAC) when connected to AC power.
After all connections have been made, connect the supplied AC Power Cord to an
unswitched AC power outlet.
2. IR SENSOR - IR sensor ‘sees’ the IR commands from the D2.1 IR Remote, or other properly
configured programmable remote to control D2.1 Power, Volume, EQ Input, etc.
3. LINE IN (L&R) - Two RCA jacks. Analog audio sensing input. The D2.1 can be configured to
turn ON when an audio signal is present on these jacks. (See section: Operation/ON/OFF.)
The amp will turn OFF when no audio input has been sensed for fifteen minutes. Using a
stereo RCA cable with gold ends, connect to the L&R line level audio output on a source to
be played though the D2.1. If the source has variable output be sure to lower the volume
on the source prior to turning the source and amp on the avoid unintentional damage to
the D2.1 and/or speakers. Set source to an appropriate output level during audio level
setup.
4. SUB OUT - One RCA jack. Outputs line level low frequency content to a powered
subwoofer. Using a mono RCA cable, connect to the Sub IN or LFE jack on a powered
subwoofer.
5. SPEAKER TERMINALS - Four-position plug-in screw terminal. Outputs speaker level
audio to left and right channel speakers or a sound bar. Using 16AWG (min) speaker
wire, connect to the appropriate speaker terminals on a sound bar or left and right
speakers. Before connecting the speaker wire to the amp, twist the ends of the speaker
wire so there are no loose ends that can cause shorts. Observe proper polarity. Confirm
connections.