Vari Lite VL2000 User Manual - Www.Carlosmendoza.Com.Mx
VARI
❋
LITE® - VL2000™ S
POT
L
UMINAIRE
U
SER
’
S
M
ANUAL
6 4
02-M ay- 03
0 2 . 9 6 7 3 . 0 0 0 1 D
To change the follow time in a sequence:
The follow time is stored for each cue individually.
Step
1. Select cue to be changed from PCue.
Step
2. Go to Mod to modify active cue and press [Enter] to save the change.
Step
3. Set FLTM (Follow Time) to desired value (refer to
“Set follow time between cues:” on
).
To delete a sequence and all cues:
Step
1. Press [Menu].
Step
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
Step
3. Press [Up] / [Down] arrows until DSEQ appears. Press [Enter].
Step
4. OK? prompt will appear. Press [Enter] to delete stored sequence.
Choose Sequence Mode:
MSEQ will replay the cues from the master luminaire.
ISEQ will play the cues from each individual luminaire, if any. In ISEQ, if the number of cues is
different, it will only play as many as each luminaire has stored. The follow time is taken from the
master luminaire.
Step
1. Press [Menu].
Step
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
Step
3. Press [Up] / [Down] arrows until SEQ appears. Press [Enter].
Step
4. Press [Up] / [Down] arrows to toggle between ISEQ and MSEQ. Press [Enter] to select
mode.
To make a sequence AutoPlay at power up:
Step
1. Press [Menu].
Step
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
Step
3. Press [Up] / [Down] arrows until Auto appears. Press [Enter].
Step
4. Use [Up] / [Down] arrows to toggle between OFF (the default) and ON. Press [Enter] to
select the mode.
To store cues from a console:
Step
1. Clear memory by deleting cues or sequence, if required.
Step
2. Recall cue at the console.
Step
3. From Cue menu, set FLTM, then at Stor store cue. If each luminaire has separate data then
store each cue into each luminaire. The sequence mode to use in this case would be ISEQ.