Vaux Electronics Marc Plus Instructions Manual - page 10
Infrared Learning
1.
Slide the mode switch to “Audio/Video”, and then Press and hold the
Learn button
on the Remote Control for 2 seconds until the green
light on the Remote Control illuminates, then release. When the
button is released, the yellow Learn light on the Receiver will
illuminate. You are now in IR learning mode.
2. Select a Device:
Press Shift-Device for the component you
are about to teach to the MARC+ System (for example, Shift-
Laser). You may change the Current Device at any time; you have
eight separate “keyboards” (or IR pages) to program.
3. You are now ready to map all of the buttons from your existing infrared
remote control(s) to the buttons on the MARC+ Remote Control.
You can learn as many buttons as you wish — one or all. If you
want to change a button that already has been taught, just learn it
again. It will replace the old command with the new infrared
command. All of the commands are stored in the Receiver, which
has a battery backup — you may unplug it without your codes
being lost.
Press the button on the MARC+ Remote Control that you want to teach
(for example, Ch Up); the green Data light on the Receiver will go
on, and the yellow Learn light will go off.
4. Hold the infrared remote control up to the sensor window
on the front
of the MARC+ Receiver (approximately 2 to 4 inches away) and press
and HOLD DOWN the button — that you want to learn — on your existing
infrared remote control
(for example, Ch Up) until the yellow Learn light
on the Receiver illuminates, then release. Note: the green Data
light on the Receiver will flash as the code is being learned.
IMPORTANT: You must HOLD DOWN the infrared remote
control button, while you are learning the code, until the yellow
Learn
light
on the Receiver illuminates. This may take a second depending on the type
of A/V device.
If there has been an error while learning, the red Error light on
the Receiver will blink; repeat steps 2 through 4 until all of the primary
10