Vaux Electronics Marc Plus Instructions Manual - page 24
Troubleshooting Guide
I press a button and nothing happens except:
1.) nothing — no lights on the Remote Control or the Receiver flash.
Dead batteries — install new batteries in the Remote Control.
2.) the red
Error
light on the Remote Control flashes and no lights on the Receiver
flash.
You have pressed an invalid button or sequence of buttons.
3.) the green light on the Remote Control flashes, but no lights on the Receiver flash.
The Remote Control has sent a valid command, but the Receiver has not
sensed it; the cause may be one of the following:
a.)
You may be located too close to the Receiver (less than 2-3 feet
may overload the Receiver.)
b.)
Your Security Identification Codes in your Remote Control and
Receiver may not match. Reset the Remote Control to factory settings by
removing its battery for approximately a minute. Reset the Receiver to
factory settings by pressing the button on the bottom of the Receiver for
one second until the green Data light flashes; this will also clear out the
infrared memory in preparation for a new learning session.
c.)
You may be having interference or other transmission problems;
for example, you may be located in an office that has metal studs, or
d.)
You may be located out of range of the Receiver.
4.) the green light on the Remote Control flashes and the red
Error
light on the
Receiver flashes.
The Remote Control has sent a valid command and the Receiver has
sensed the command, but the Receiver considers it an invalid command.
Your problem may be one of the following:
a.)
If you are sending X-10 commands for lights and appliances, then
you may not have the X-10 Interface Module connected (or its outlet
switched off), or
b.)
If you are sending X-10 commands, you may have a defective X-
10 Interface Cable, or
c.)
If you are sending infrared commands, you may have not
programmed the Receiver with an infrared code for that device's button.
5.) the green Data light and the red
Error
light on the Receiver flash together.
The Security ID Codes do not match.
24