Vaux Electronics Marc Plus Instructions Manual - page 18
MARC+ Remote Control for the 1-digit X-10® operation. This
gives you a quick reference guide.
Zone "0" commands all modules, on the default House Code,
to respond to the X-10 "All Lights On" and "All Units Off"
commands.
c.
Press the On or Off button to control the X-10 Module.
(NOTE: In order to dim or brighten a light, the light must
be turned on, then dimmed, then brightened. This an X-10
defined operation. See steps 3 and 4.)
Example
With the 1-digit operation method, the factory-setting house
code is set to "A". For example, either an X-10 module placed in
the Living Room should be set to a house code of "A" and a unit
number of "1". A module placed in the Dining Room should be set
to a house code of "A" and a unit number of "2", etc.
If you hear a noise at night, 0-On turns on lights in the whole
house.
3.
Dimming/Brightening Lamp Modules:
In order to dim a light, the light will be first be turned on
and then dimmed. Only the last module which was turned on is
affected. Actually, the last light turned Off will also dim (from full
bright), but will not brighten from full off. This an X-10 defined
operation.
Note: Macros can be used to preset modules On and fully
dimmed. They can then be brightened from this pseudo-off point.
Note: Appliance modules do not respond to the Dim/Bright
commands, since they use relay switching.
a.
Slide the Mode switch to the Lts/App positions
b.
Press Chan Up/Down, or the Vol Up/Down buttons, and hold until
the lamp is dimmed/brightened to the desired level.
18