Vax Mach3 U90-M3 series Instruction Manual

Manual is about: Bagless upright

Summary of Mach3 U90-M3 series

  • Page 1

    Vax.Co.Uk please read carefully before using this cleaner. Always fully extend the mains cable before use. Retain for future reference. In st ru ct io n m a n u a l bagless upright vax model number: u90-m3 series u90-m4 series version 1.4 vax careline: (uk) 0844 412 8455 (roi) 1-800 928 308 warning:...

  • Page 2

    1. Diagram vax.Co.Uk 2 parts overview 1 1 handle grip 2 on/off switch 3 telescopic handle 4 handle release button 5 carry handle 6 dirt container release button 7 dirt container assembly 8 dirt container hinge 9 stair cleaning handle (located below edge of dirt container) 10 headlight 11 carpet heig...

  • Page 3

    3 safety information vax careline: (uk) 0844 412 8455 (roi) 1-800 928 308 2. Safety information for household use only when using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. Only use the vacuum cleaner indoors on dry surfaces. Do not handle the...

  • Page 4

    Vax.Co.Uk 4 assembly 3. How to assemble attach handle grasp orange tie wrap and pull until the black plug comes out of the handle cavity (fig.3/1). Hold plug with one hand; upper handle with the other hand. Push plug into upper handle, aligning with opposite end of plug and push firmly until you hea...

  • Page 5

    5 operation 4. How to operate carrying cleaner the cleaner can also be moved by using the carrying handle (fig.4/1). Handle positions the handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating position for general operation on carpet and floors; low ...

  • Page 6

    Vax.Co.Uk 6 operation as an alternative, you may use the hose and power hand tool for stair cleaning. Clean from bottom to top. Note: when using cleaning tools, the brushbar will continue to rotate. Caution: to avoid personal injury or unnecessary wear to carpet, and to prevent the cleaner from fall...

  • Page 7

    7 dirt container and filters 5. Dirt container & filters: removal & replacement note: familiarise yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. Emptying the dirt container empty the dirt container before the dirt reach...

  • Page 8

    Vax.Co.Uk 8 dirt container and filters remove dirt container as described above. Twist filter assembly counterclockwise. Remove assembly from dirt container (fig.5/6). Dirt and debris can be cleaned from the filter assembly by brushing with the cleaner’s combination tool. Place the filter assembly o...

  • Page 9

    9 maintenance to remove the hood, press handle release pedal and place handle in low position. Using a coin, turn the two slots (a) on either side of the hood as shown (fig.6/3). Rotate hood toward front of cleaner and remove the hood (fig.6/4). Remove brushbar and used belt (fig.6/5). Discard used ...

  • Page 10

    Vax.Co.Uk 10 maintenance grasp brushbar firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (a) on side of cleaner. Pull other side of brushbar (b) into place (fig.6/7). Turn brushbar making sure belt turns freely and is not pinched between brushbar and b...

  • Page 11

    11 maintenance remove brushbar including end plates (a) and discard. Inspect belt to ensure that it is in good condition. If belt is cracked, gouged or broken, replace it (see following section). Insert brushbar through belt and position belt over gear teeth (b) on brushbar (fig.6/12). With curved e...

  • Page 12

    Vax.Co.Uk 12 maintenance / clearing blockages with flat sides of turbine retainers (a) pointing down, slide retainers into grooves (b) in tool housing and snap into place (fig.6/18). Replace brushbar, belt guard, and bottom plate as described previously. 7. Clearing blockages important: disconnect c...

  • Page 13

    13 clearing blockages / troubleshooting reposition tube on back of cleaner, replace 5 screws. Checking under hood turn cleaner off and unplug. Remove hood, belt and brushbar as described in previous section. Look into opening (a) for blockages and remove (fig.7/4). Replace belt, brushbar and hood. I...

  • Page 14

    Vax.Co.Uk 14 uk service & help / technical specification 9. Uk service & help vax careline: (uk) 0844 412 8455 (roi) 1-800 928 308 monday-friday 8.30am to 6.30pm. Saturday-sunday 9.00am to 5.00pm. Any queries or concerns about using the vax, call the vax careline. Please make a note of the serial nu...

  • Page 15

    15 this page has been left intentionally blank. Vax careline: (uk) 0844 412 8455 (roi) 1-800 928 308 u90-m3 & m4 series user guide v1.4.Qxd:ug 15/7/10 15:37 page 15.

  • Page 16

    Eec statement of compliance manufacturer/eec importer: vax limited, hereby on our own responsibility, declare that the u90-m3 mach 3 series and u90-m4 mach 4 series upright vacuum cleaners are manufactured in compliance with the following directives: safety: 2006/95/ec low voltage directive emc: 200...