Vax Mach3 U90-M3 series Instruction Manual - page 6
vax.co.uk
6
operation
As an alternative, you may use the hose and power hand
tool for stair cleaning. Clean from bottom to top.
NOTE: When using cleaning tools, the brushbar will
continue to rotate.
CAUTION: To avoid personal injury or unnecessary
wear to carpet, and to prevent the cleaner from
falling, always place it at bottom of stairs.
Cleaning Tools
Tools allow for cleaning surfaces above the floor and for
reaching hard to clean areas.
The cleaner is ready for tool use when handle is in
upright position.
CAUTION: The brushbar continues to rotate
while cleaner handle is in upright position.
Avoid tipping cleaner or setting it on furniture,
fringed area rugs or carpeted stairs during tool use.
How to Clean Tools
To clean the hose, wipe off dirt with a cloth dampened in
a mild detergent. Rinse with a damp cloth.
Cleaning tools may be washed in warm water with a
detergent. Rinse and air dry before using.
Removing Hose
When using cleaning tools, cleaner handle should be in
the upright position. Turn cleaner OFF before
disconnecting and connecting hose to hose tube (A).
To use hose, lift hose end (B) as shown. Check to be sure
the hose tube cover (C) is closed over the hose tube
(Fig.4/6).
When you are finished cleaning with the tools, lift cover
from hose tub and reposition hose end into tube.
Select Correct Tool
2-in-1 tool: use with brush for carved furniture, table
tops, books, lamps, lighting fixtures, venetian blinds,
skirting boards and shutters.
Remove brush to clean upholstered furniture, draperies,
mattresses, clothing, and carpeted stairs.
TurboTool: may be used for upholstered furniture,
draperies, mattresses, clothing, car interiors, and carpeted
stairs.
Crevice tool: may be used in tight spaces, corners and
along edges in such places as dresser drawers,
upholstered furniture, stairs and skirting boards.
Wands: are used to give extra length to your hose. Use
them with any of the above tools.
Hard floor tool: (available on some models only) use on
hard surface floors.
Attach Wand and Tools
Attach tool or wand to the hose. Attach tool to wand by
pushing it firmly onto the wand. Twist wand or tool
slightly to tighten or loosen the connection.
2-in-1 tool
Slide brush to remove. To replace brushes, align bottom of
brush with grooves on tool. Slide brush into place (Fig.4/7).
!
!
Fig.4/5
Fig.4/6
Fig.4/7
B
A
C
U90-M3 & M4 Series User Guide v1.4.qxd:UG
15/7/10 15:37 Page 6