Vax Mach3 U90-M3 series Instruction Manual - page 8
vax.co.uk
8
dirt container and filters
Remove dirt container as described above. Twist filter
assembly counterclockwise. Remove assembly from dirt
container (Fig.5/6).
Dirt and debris can be cleaned from the filter assembly by
brushing with the cleaner’s combination tool.
Place the filter assembly on the dirt container, aligning
tabs (A) on either side of filter with slots on dirt container
(B) and twist it clockwise to secure into position.
Press dirt container door release button (C) to latch dirt
container door closed (Fig.5/7).
Replace dirt container as described above.
Cleaning the Secondary Filter
IMPORTANT: Disconnect cleaner from electrical
outlet. Do not operate cleaner without dirt
container or filters in place.
Remove dirt container as previously described.
Pull down on latch (A) located at the top of the dirt
container cavity to remove grey filter frame (B). Remove
white fabric filter and black foam filter from frame. Hand
wash filters in cold water with a mild detergent.
Allow filter frame and both filters to air dry for 24 hours
before replacing filters into filter frame.
Reposition filter frame by inserting tabs (C) into slots (D) on
back of dirt container cavity. Rotate filter frame up toward
top of dirt container cavity and snap closed (Fig.5/8).
Cleaning the Final Filter
IMPORTANT: Disconnect cleaner from electrical
outlet. Do not operate cleaner without dirt
container or filters in place.
Remove dirt container as previously described.
Pull filter frame (A) straight out from bottom of dirt
container cavity. Do not attempt to remove filter (B) from
frame (Fig.5/9).
Hand wash in cold water with a mild detergent.
Allow to air dry for 24 hours before replacing frame into
bottom of dirt container cavity.
Fig.5/6
Fig.5/8
Fig.5/7
Fig.5/9
A
A
A
B
B
C
D
B
C
!
!
U90-M3 & M4 Series User Guide v1.4.qxd:UG
15/7/10 15:37 Page 8