VDG FH1500-WR Owner's Manual - Control Panel Operation
8
Control Panel Operation
BUTTON
OPERATION / FUNCTION
CONTROL PANEL DIAGRAM
Power
Press once: Power and indicator
turn on. Functions are enabled.
Press again: Power, indicators,
and all functions turn off.
Temp
Temp
Temp: Press or to select
the temperature setting.
The heater will turn on and off
automatically to maintain the set
temperature.
To view the room temperature,
press both buttons at the same
time. The room temperature will be
displayed for 5 seconds.
Afterward, the display will again
show the set temperature.
Heat Setting
Mode
Heat Level: Press H/L to choose
between High Heat (1500W) and
Low Heat (1000W). The
H or L
indicator on the heater will display
the setting.
Mode: Press °C/°F to change the
temperature display readout from
°
C to °F. The indicator will display
the setting.
Time
Time: Press Time to display
numbers from “0” to “8”. Number
“0” means the timer is not set, and
the heater will run continuously.
Numbers “1” - “8” show the
number of hours the heater will run
before it automatically turns off.
Press to set the desired time.
Note: The fan will continue to run after the thermostat temperature is reached, the timer runs out, or
the heater is turned off - either by the control panel or the remote control. This is normal.
A) Fan-only run time varies. In thermostat mode the fan runs for 8 minutes after desired room
temp is reached, and 3 minutes after the timer runs out, or power is turned off. This makes use of
residual heat collected inside the heater. It also cools the heater, which prolongs its lifetime.
B) In thermostat mode, the heater may appear to run constantly if the room temperature drops
below the thermostat setting during the fan-only period. In fact, it has only cycled off and on again.