VDG FH1500-WR Owner's Manual - Remote Control Operation
9
Remote Control Operation
BUTTON
OPERATION / FUNCTION
CONTROL PANEL DIAGRAM
Press once: Power and indicator
turn on. Functions are enabled.
Press again: Power, indicators,
and all functions turn off.
Temp
Temp: Press or to select the
temperature setting.
The heater will turn on and off
automatically to maintain the set
temperature.
To view the room temperature,
press both buttons at the same
time. The room temperature will be
displayed for 5 seconds.
Afterward, the display will again
show the set temperature.
Heat
Heat Level: Press H/L to choose
between High heat (1500W) and
Low heat (1000W). The
H or L
indicator on the heater will display
the setting.
Time
Time: Press Time to display
numbers from “0” to “8”. When set
to “0”, the timer is not set, and the
heater will run continuously.
Numbers “1” - “8” show the
number of hours the heater will run
before it automatically turns off.
Press to set the desired time.
Remote Control Battery
•
This remote control uses
one CR2032 Lithium-ion 3 volt button cell battery (included).
•
Instructions for battery installation are inside the Remote Control battery compartment.
•
Always replace the battery in the remote control with the same type of battery.
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion.Dispose of batteries at your local hazardous material processing center.