Vega VEGAFLEX FX-E.80A Operating Instructions Manual - page 11
11
5 Setup
Electronics module • VEGAFLEX 80 series
43656-EN-170531
After entering the instrument serial number, the order data of the
sensor will be displayed.
3. Belowtheorderdata,youcanfindunder"Sensor data for service
DTM"theXMLfile:"DTMConfigurationFile".
ClickwiththerightmousekeytothefileanddownloadthisXML
filewith"Save target under" to your PC.
4. ForinstrumentswithSILqualificationyouhavetodownloadthe
PDF document "SIL electronics exchange check sum certificate"
also from the homepage.
ClickwiththerightmousekeytothefileanddownloadthisPDF
filewith"Save target under" to your PC.
5. ComparetheserialnumberoftheXMLfilewiththeserialnumber
of your sensor.
Youcanfindtheserialnumberoutsideonthetypelabelofthe
instrument and inside the housing.
6. Start PACTware and connect to the corresponding sensor.
7. Openthefield"Maintenance" and select"Electronics exchange"
8. After the connection is established, you can choose how the sen-
sor data should be loaded to the sensor.
Choose "Load sensor data from local file"
9. Click the button "Selection"toloadtheXMLfilefromthefile
system of your computer.
Makesurethatyouareusingthecorrectfile.
10. As soon as the sensor data are ready, you can load the data
directly into the sensor.
This procedure lasts approx. 5 minutes.
11. Thenallapplication-specificsettingsmustbeenteredagain.See
the following chapter "Setup steps"
InstrumentswithSILqualification
After the transfer of the sensor data, a check sum is displayed. You
have to verify the correct transmission by means of a check sum.
Only then, the instrument will be ready for operation, again and SIL
qualified.
Go in the via our homepage "www.vega.com" to "Instrument search
(serial number)".
Enter the serial number of your sensor.
After entering the instrument serial number, the order data of the sen-
sor are displayed.
Download the PDF document "SIL electronics exchange check sum
certificate" from the homepage. Compare the check sum with the data
of the PDF document.
If the check sums match, the transmission was successful. Record
the comparison of the check sums.