Vegas LedSync820C User Manual - Led Video Processor
LedSync820C User’s Manual
---------------------------------------------------------------------------------------------------
LED VIDEO PROCESSOR
9
2. Setup of LedSync820C output image
LedSync820C can setup its output image by operating the buttons
on frontal panel. After LedSync820C is started up, all buttons on frontal
panel are in operation mode. As above section III.2 describes, if you
press “STD” button for continuous 18 times, LedSync820C will enter
setup state, and all buttons on frontal panel are ready to be in setup
mode. See the table below for the definitions of each button:
Name
Description
Move output image leftward.
Hor_Str
Move output image rightward.
Decrease width of output image
Hor_Width
Increase width of output image
Move output image upward.
Vert_Str
Move output image downward.
Decrease height of output image
Vert_Height
Increase height of output image
-
Decrease video
color
Video_Color
+
Increase video
color
Standard color value=0. -
16 represents the lowest
color, +16 represents the
highest color
Save
Save currently adjusted values
Setup
Press the button for continuous 18 times,
LedSync820C will enter setup state, press
it again, LedSync820C will exit setup state
and enter operation state.
Step
Select step value 1 or 10
Notes:
a) Generally Hor_Str≥0. If you need modify it, the value of
Hor_Str can be setup to be – 8;
b) Generally Vert_Str≥0. If you need modify it, the value of
Vert_Str can be setup to be – 5 ;