Range hoods installation instructions - use and care intended for domestic cooking only installer: leave this manual with homeowner. Homeowner: cleaning and operation information on pages 8 to 11. 07020 rev. C read and save these instructions ! !.
Warning warning - 2 - to reduce the risk of fire, electric shock or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servici...
Because of the large amount of models covered by this publication, the illustrations are typical ones. Some details of your unit may be slightly different of the ones shown. Please take note this manual uses the following symbols to emphasize particular information: note: indicates supplementary inf...
1. Install ductwork plan where and how the ductwork will be installed. Install proper-sized ductwork, elbow(s) and roof or wall cap for the type of blower you are installing. If using 6’’ (150 mm) round ducts, use a transition. Use 2’’ (50 mm) duct tape to seal duct joints. Hood 3¼” x 10” duct roof ...
3. Prepare the installation (cont’d) 4. Prepare the hood note: if the bottom of the cupboard is recessed, attach wood strips (not included), as shown below, in order to properly install the range hood ( a ) or charcoal filter unit (if need be) to the cabinet ( b ). The wood strips must be as thick a...
4. Prepare the hood (cont’d) using a long nose pliers, remove the knock-outs for the chosen opening (vertical on top or horizontal at the back of the hood). See figures below. V ertical discharge : h orizontal discharge : note: for the best ventilation performance, if a round duct must be used, the ...
Connect cable to range hood wiring using included wire connectors. Connect black to black, white to white and green or bare wire to green ground screw ( 1 ). 6. Install the hood run power cable to installation location. Place the hood at its location. Using a pen, mark the position of the screws (sm...
To remove lamps, gently push upward and turn counterclockwise to disengage bulb leads from their grooves. 9. Halogen light bulbs this range hood must use 120 v, 50 w, mr16 with gu10 base or par16 with gu10 base, shielded halogen lamps (purchase separately). Install the lamps by placing the bulb lead...
S tainless steel cleaning ( cont ’ d ): avoid: when choosing a detergent - any cleaners that contain bleach will attack stainless steel. - any products containing: chloride , fluoride , iodide , bromide will deteriorate surfaces rapidly. - any combustible products used for cleaning such as acetone ,...
M echanical p ush -b utton c ontrol a. Off b lower s witch : press on this switch to stop the blower operation. B. S peed b lower s witches : press on left switch ( 1 ) to turn on the blower on low speed, on middle switch ( 2 ) to turn on the blower on medium speed, and on right switch ( 3 ) to turn...
R ound e lectronic c ontrol a. D elay s witch : when a blower speed is selected, press this switch to activate the delay function. The corresponding blower speed switch will flash to indicate this function is activated. The blower will continue to operate for 5 minutes and will stop automatically. T...
K ey p art q ty per s erie n o . N o . D escription c600e c600m v40e ed600e 1 13296 a dapter /d amper 1 1 1 2 16153 s moked glass 1 1 - 16150 g lass holder black ( the pair ) 1 1 - 3 16151 g lass holder white ( the pair ) 1 1 - 16152 g lass holder grey ( the pair ) 1 1 - 4 01988 b lower wheel 2 2 2 ...
