Venmar C180 SERIES Installation Instructions & Use And Care - page 7
Connect cable to range hood wiring using included wire connectors.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or BARE WIRE
to GREEN ground screw (
1
).
6. INSTALL THE HOOD
Run power cable to installation location. Place the hood at its location. Using
a pen, mark the position of the screws (smaller part of the
embossed
keyholes). Remove the hood and install (4) 1/2” double thread screws at
sides locations (
A
), leaving a 1/8” gap. Place the wire clamp, insert the cable
in the hood and tighten the wire clamp to secure the cable. Place the hood
under the cabinet and slide it in position. Make sure the adapter/damper
assembly enters the ducting and the damper opens freely. Secure the hood by
tightening the screws completely. Install the last 1/2” double thread screw (
B
)
in the remaining embossed hole.
WARNING
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable codes
and standards. Before connecting wires, switch power off at service panel and lock service disconnecting means to
prevent power to be switched on accidentally.
!
7. CONNECT WIRING
HE0059
WARNING
Do not forget to connect the ground!
CAUTION
Remove protective plastic film covering filters before reinstalling them (if need be).
!
8. REINSTALL BOTTOM PANEL
Reinstall the bottom panel, using 5 screws for a single blower hood and 6 screws for a double blower hood, as shown below.
S
INGLE
BLOWER
HOOD
DOUBLE
BLOWER
HOOD
Then, reinstall filters.
HO0059
HO0066
- 7 -
1
HD0154
A
A
B