Cpm series intended for domestic cooking only installer: leave this manual with homeowner. Homeowner: use and care information on pages 12 and 13. Venmar ventilation inc., 550 lemire blvd. Drummondville qc j2c 7w9 1-800-567-3855 register your product on line at: www.Bnv.Ca for additional information...
Warning warning - 2 - to reduce the risk of fire, electric shock or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servici...
- 3 - - cpm1 and cpm2 power pack system - hl0107 8” r ound adjustable elbow cpm2 power pack cpm1 power pack m odel 634 or 644 (r oof cap ) m odel 643 (8” r ound wall cap ) 8” r ound standard duct a dapter and damper 8” round ( supplied with single blower power pack ) m odel 437 (h igh capacity roof ...
2. Install ductwork and electrical wiring plan where and how the ductwork will be installed. Access to the top of the hood is preferred for connection of ductwork. Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. If installing cpm1 power pack, use...
2. On 42” width model only, for each side filters, slide out filter filler (shaded part on illustration beside). - 5 - 4. Mount custom hood internal framework 5. Remove filters 6. Remove grease drip rail remove tape on filters. Remove filters from power pack and set aside. Notes: 1. It is recommende...
8. Remove the knock-out opening from inside the power pack, remove the wiring cover by removing two (2) retaining screws and set aside. Punch out the electrical knockout hole on top of the hood. Install the wire clamp (included in parts bag). Hr0027 9. Install the adapter/damper (cpm1 models only) u...
11. Connect wiring connect cable into wiring box using provided wire connectors. Connect wires as follow: black to black, white to white and green or bare wire under ground screw. Do not forget to connect the ground. Reinstall wiring cover. Warning risk of electrical shock. Electrical wiring must be...
- 8 - cpm2 m odel for each blower, using a 5/16” socket, remove all blower mounting screws from the inner top of the power pack front and rear brackets. Set aside the screws. Hd0297 for each blower, slide it to disengage its flanges from the retaining brackets. Set aside the blowers. B lowers f ront...
- 9 - cpm2 m odel for each blower, using a 5/16” socket, secure the blower to the inner top of the power pack through the front and rear brackets with all blower mounting screws (previously removed in step 12). Hd0297 for each blower, slide it to engage its flanges in both retaining brackets. Note: ...
- 10 - 15. Reinstall bottom panel lift the bottom panel and engage the power pack metal tabs in bottom panel slots, as shown in details a and b below. Secure the bottom panel to the power pack using its screws previously removed in step 7. A b ho0112 ho0110 r etaining s crew l ocation 16. Reinstall ...
- 11 - 17. Reinstall baffle filters notes : 1. On 42” width model only, reinstall both filter fillers previously removed in step 5. 2. Assemble the metal handles to the filters, using provided no. 8-32 x 1/4” screws, before installing them in the power pack. It is recommended to install side filters...
- 12 - hood cleaning stainless steel cleaning: avoid: when choosing a detergent - any cleaners that contain bleach will attack stainless steel. - any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly. - any combustible products used for cleaning such as aceto...
- 13 - 20. Operation always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner and brighter. Heat sentry™ this hood is equipped with a he...
- 14 - warranty venmar ventilation five-year warranty venmar ventilation inc. Warrants to the original consumer purchaser of the venmar connaisseur cpm series range hood that such product will be free from defects in materials or workmanship for a period of five (5) years from date of original purch...
- 15 - 22. Wiring diagram line neutral ground 12 0 v ac wht m brn blu red blk m brn blu red blk wht s peed control h s thermo s tat blu blk blk blu blk wht wht wht wht blk blk yel yel lamp lamp s witch l 1 2 fan s witch blu blu blu blu lamp color code he0092a blk black blu blue brn brown red red wht...
- 16 - 23. Service parts venmar connaisseur cpm1 & cpm2 series * n ot shown . K ey no . P art no . D escription q ty . ( power pack width ) 30” 36” 42” 48” 1 08543 a dapter /d amper 8” r ound 1 1 1 - 2 08541 a dapter 10” r ound - - - 1 3 08097 i nternal b lower 1 1 1 2 4 16569 l amp s hell , s ocket...
