Summary of P1
Page 2
Safety precautions safety precautions specifications specifications 2 • never swim out to retrieve an r/c boat that has stalled in the water. If you are going into the water, use a small boat or kayak to retrieve your model, always wear a pfd (personal flotation device). • never stand in the water w...
Page 3
T hank you for purchasing your new venom™ king of shaves p1 35” rtr electric boat. This rtr electric boat was designed with both beginning r/c boat hobbyists and die hard boat enthusiasts in mind. Racers will love the adjustability and tunability of the hull and drive system, enthusiasts will enjoy ...
Page 4
4 1) press enter to access the function menu. 2) press the key 4 times to highlight the “mdl” (model) menu and press the “enter” key. 3) with highlighted press the enter key to enter the stored model profiles. 4) use the keys to move through the stored models and select the “p1” profile. 5) press “e...
Page 5
5 step #1. Enter the programming mode. Switch on the transmitter. Move the throttle trigger to the full throttle position and then connect the battery pack to the esc. Wait for 2 seconds, the motor emits “beep-beep” tone. Wait for 5 seconds, the motor emits a special musical tone noting that the pro...
Page 6
6 slide the prop onto the drive shaft making sure to align the notch with the drive dog. Use the supplied lock nut to secure the prop to the propshafts. Use caution when installing the prop as it may have extremely sharp edges. If you are using a aftermarket prop, make sure it is sized for a 4mm pro...
Page 7
7 1. Thread the antenna from inside the hull up through the base of the antenna tube holder. 2. Thread the antenna through the antenna tube. 3. Seat the antenna into the antenna tube holder and then cover the end with the rubber cap. 4. For added security, you can use a small piece of silicone tubin...
Page 8
8 secure the hatch by sliding the front pin into the hole at the front of the hull opening. The hatch should drop easily down so that the magnets hold the hatch securely in place. To waterproof the hatch, use strips of clear tape to seal the lid on all four sides. Basic controls basic controls insta...
Page 9
9 see page 6 loosen the drive using a pair of needle nose pliers and a 2.5mm hex driver. Adjust the drive up or down to change the running angle of the boat. Use the etched angle markings on the drive as a guide. The alignment of the propeller shaft is parallel to the bottom of the hull (keel) which...
Page 10
7 8.
Page 11
11 boat maintenance boat maintenance drive line 1. Remove the prop. 2. Loosen the motor coupler set screws for the flex cable. 3. Slide the flex cable out of the drive. 4. Lubricate the flex cable with marine grease. 5. Lubricate the drive ball bearings with a light oil for bearings. 6. Reassemble t...
Page 12
12 problem cause fix speed control does not operate. 1. Transmitter and/or receiver is not switched on. 1. Switch on. 2. Batteries are not fully charged. 2. Charge batteries. 3. Improper radio installation. 3. Reinstall correctly. Motor does not operate. 1. Batteries are not fully charged. 1. Charge...
Page 13
13 setup notes setup notes.
Page 14
14 setup notes setup notes motor & esc servo prop & drive angles cg range 210-230mm mm mm mm.
Page 15
15 battery boat weight and setup specs.
Page 16
1816 venom group international 14028 n. Ohio street rathdrum, id 83858 customer service customerservice@venom-group.Com 800.705.0620 208.762.0620 (outside usa) australia po box 7325 alexandria nsw 2015.