VENOM P1 Instruction Manual And Tuning Manual - page 9
9
See page 6
Loosen the drive using a pair of needle nose pliers and a 2.5mm Hex Driver. Adjust the drive up or down to change the
running angle of the boat. Use the etched angle markings on the drive as a guide.
The alignment of the propeller shaft is parallel to the bottom of
the hull (Keel) which is considered zero degrees (0 deg) and a
neutral setting. The thrust of the propeller is in line with the
center of the hull and has no effect on the hull ride angle.
TUNING GUIDE
TUNING GUIDE
REPLACING/ UPGRADING THE PROP
ADJUST AND MEASURE THE DRIVE SHAFT
NEUTRAL THRUST ANGLE (0 DEGREES)
The trim tabs are used to adjust the bow angle of the hull and add stability. To adjust the trim tabs tighten or loosen the
screw above the tab. For example, tightening the screw will cause the bow of the boat to ride lower suitable for rough
conditions.
ADJUSTING TRIM TABS
1
2
2.5mm
Hex Driver
Note: See page 15 to save your set up.
Bow Up
Neutral
Bow down
Bow Up
Neutral
Bow down