VENOM VEN-8181 Quick Manual - page 9
9
2.11 FUNCTION / MODULATE
2.12 FUNCTION / BR_MIX (BRAKE MIX)
This is used to bind the VR3T to the 3 Ch 2.4ghz receiver.
NOTE: The Bind plug will be needed for this step.
1) Plug the Bind plug into channel 1 of the 3 Ch 2.4ghz receiver.
2) Turn on power to the 3 Ch 2.4ghz receiver.
3) Turn on the power on the VR3T transmitter.
4) Press
ENTER to see the FUNCTION MENU.
5) Use the
+/- Keys to select the MODULATE function and press ENTER.
6) Use the
+/- Keys to select YES.
7) Press
ENTER to bind the 3Ch 2.4ghz receiver to the VR3T Transmitter.
8) When it says
SET OK, binding is complete.
9) Press
EXIT to save and return to the FUNCTION menu.
This is used to mix a secondary braking system run off the
AUX channel with the throttle
channel. When using the secondary braking system, set the
BRAKE MIX value to a
percentage of the Throttle Brake. When using a secondary braking system, it will control
the rear brakes with the front brakes being controlled by the throttle brake. The
TH TRIM
and
TH EPA is then used to fine tune the power and balance of the overall braking
system.
1) Press
ENTER to see the FUNCTION MENU
2) Use the
+/- Keys to select the BK_MIX function.
3) Press enter to select a item.
4) Use the
+/- Keys to change the value
5) Press
EXIT TWICE to save and return to the FUNCTION menu.
Terms:
RATE – The rate of brake between the 3rd channel and the 2nd channel.
Range: 0%~120%, 0% default.
EN – Option to Enable the Brake Mix feature.
BIND SCREEN
BIND SCREEN