Vent-Axia 2kW Installation And Operating Instructions - page 2
IMPORTANT Read these instructions fully before using the heater.
Retain these instructions for future reference.
The heater has a loading of 2kW. It is designed for permanent wall mounting and is suitable for operation on A.C
electricity supply having the same voltage as shown on the rating label.
IMPORTANT SAFETY ADVICE (to be read before operating the heater)
1) This product is a wall mounting appliance, never use it as portable appliance.
2) Do not use the heater unless the feet are correctly attached if the heater is used as portable appliance.
3) This heater in designed for wall mounting and must be used with the warm air vent facing downwards. This
heater should not be used in any other orientation and should not be used as a free standing portable
appliance.
4) This product is suitable for installation on surfaces with normal flammability e.g. wood, plasterboard,
masonry. It is not suitable for use on highly flammable surface (e.g. polystyrene, textiles)
5) The heater is to be installed so that switches and other controls cannot be touched by a person in the bath
or shower.
6) Before making fixing hole(s), check that there are no obstruction hidden beneath the mounting surface
such as pipes or cables.
7) The chosen location of your new heater should allow for the product to be securely mounted(e.g. to a firm
wall) and safely connected to mains supply
8) Ensure the power supply to the heater is in accordance with the rating label on the heater.
9) Keep the mains lead away from the hot body of the heater.
10) Do not use outdoors.
11) Do not cover or obstruct any of the heat outlet grilles or the air intake openings of the heater.
12) Do not place the heater on carpets.
13) Always ensure that the heater is placed on a firm level surface. Ensure that the heater is not positioned
close to curtains or furniture as this could create a fire hazard.
14) Do not position the heater in front of, or immediately below, a wall socket.
15) Do not insert any object through the heat outlet or air intake grilles of the heater.
16) Do not use the heater in areas where flammable liquids are stored or where flammable fumes may be
present.
17) Particular care should be taken when the heater is situated in areas occupied by children.
18) Do not use the heater if the power cord is damaged. If the power cord is damaged it must be replaced by a
recognised service engineer or other qualified person.
19) Only use a suitable 220-240V electrical socket.
20) The room which is to be heated should not contain any easy inflammable materials (e.g., petrol, solvents,
spray cannisters etc.) or other easy combustible materials (e.g., wood or paper). Keep such materials away
from equipment. Risk of fire!!
21) This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance
Heater operation:
The fan heater controls are set via the pull cord located
on the bottom right hand side of the unit.
Only a gentle pull is required. DO NOT pull the cord hard
as this may damage the switch inside the heater.
1.
Switch position indicator
2.
Pull cord switch
1
2