Vent-Axia 2kW Installation And Operating Instructions - page 3
MOUNTING THE WALL HEATER
1.
The heater is secured to the wall with three screws (provided). Mark the position of the three holes on the wall
(Diagram A & B) Make the holes 8mm diameter to a depth of 40mm in the wall.
2.
Insert the three plastic Wall plugs (provided) into the holes. (Diagram C) Screw the 2 outside screws into the
wall plugs to leave 5mm protruding from the wall (Diagram D)
3.
Using the 2 slots on the back of the heater hang the product on the 2 screws. (Diagram E)
4.
Using the last screw fit the white plastic retaining bracket to the wall (Diagram F) to secure the heater.
Figures for wall mounting
Mounting the heater
Note:
This product is suitable for mounting in Zone 3 or the safe zone of a bathroom ( or similar ) only if a permanent
connection to the mains supply is made in accordance with the requirements of the building Regulations ( including
the wiring Regulations).
If in doubt, consult a qualified electrician.
1. Screwdriver.
2. Fixing screws.
3. Wall plugs.
1. Screwdriver.
2. Fixing screw.
3. Retaining bracket.