Vent-Axia 2kW Installation And Operating Instructions - page 4
ELECTRICAL CONNECTIONS
Before undertaking installation work, ensure the electricity supply is disconnected from any relevant fixed
wiring. The heater is supplied with a pre-connected length of cable. This appliance should therefore be
installed by a competent electrician in accordance with the IEE wiring regulations. The supply circuit must
be adequate for the input of the appliance and must be protected with a 10A fuse.
A suitable termination to the fixed wiring of the premises must be provided adjacent to the final position of the
appliance through a double pole switch having a contact separation of at least 3mm in all poles
.
Make the electrical connections to the double pole switch as follows:- the brown wire (live) to terminal marked L the
blue wire (Neutral) to terminal marked N. This appliance is a class II product and MUST not be earthed.
NOTE: When the heater is first turned on or when it is turned on after not been used for a long period of
time that the heater may emit some smell and fumes. This will disappear when the heater has been on a
short while
.
Safety
Cut-Out
For your safety, this appliance is fitted with a thermal cut-out. In the event that the product overheats, the cut-out
switches the heater off automatically.
To bring the heater back into operation, remove the cause of over heating, then turn off the electrical supply to the
heater for a few minutes. When the heater has cooled sufficiently reconnect and switch on the heater.
CLEANING THE HEATER
WARNING: BEFORE UNDERTAKING CLEANING OR MAINTENANCE WORK ON THE APLLIANCE
IMMEDIATELY DISCONNECT THE ELECTRICITY SUPPLY BY SWITCHING OFF AT THE ADJACENT
DOUBLE POLE SWITCH.
1) Always disconnect the heater from the mains supply and allow it to cool down before cleaning.
2) Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use any
detergents or abrasives and do not allow any water to enter the heater.
INFORMATION ON THE DISPOSAL AND RECYCLING OF THIS PRODUCT
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice in your country.
PRODUCT WARRANTY
The original purchaser is guaranteed that this product will be free from defects in workmanship and materials for a period of 1 year
from the date of purchase. Any product found to have defects in workmanship or material within the period of this warranty, will be
replaced free of charge.
The conditions of this warranty are as follows:-
A). The Product has been properly assembled and maintained.
B). Defects or damage due to normal wear and tear, accident, mis-use or interference are not included.
C). The product is made available for inspection.
D). Proof of date and source of purchase must be provided.
Note:- This warranty does not affect your statutory rights
404487A
0313
Supplied by APL