Venta Airwasher LW15 User Manual - page 18
17
1
2
3
5
replaCement of gear and Coupling
1 Place the rubber coupling into the locking ring so the rubber feet from the coupling hang
below the ring. When placing the coupling and ring on the center shaft of the fan the rubber
feet should line up with the notch marks on the fan.
2 Snap the ring and coupling into place.
3 With the gear laying on its side place it between the motor housing arms that suspend it
above the fan.
4 While placing the palms of your hands against the motor housing arms, apply slight pres-
sure, and pivot the gear to the operating (upright) position. Check that the locking knob
(flange) is properly seated. The locking knob, on either side of the gear, should fit tightly
behind the ridge of the motor housing suspension arm.
5 Insert the rubber coupling into the bottom of the gear and push it up into the gear until it fits
tight. On models with a small white pin, first insert the pin through the rubber coupling and
then push both up into the gear until it fits tight. Check that this is properly seated by spin-
ning the fan with your hand. The teeth in the gear should slowly move in and out.
serviCe option: venta airwasher
In case you prefer the factory to handle your concern, for warranty repair, or if you wish to utilize
the factory cleaning service for your Venta Airwasher, please call our customer service department
toll free at 1 (888) 333-8218 to obtain a Return Merchandise Authorization (RMA) number. Attach
a tag to the product that includes your name, address, daytime phone number, and description of
the problem. Include a copy of the original sales receipt and warranty card if not yet submitted. For
products purchased in the United States, carefully package the product in its original packaging
and send it either by UPS or Parcel Post with shipping and insurance prepaid to:
Venta Airwasher Inc, 411 Business Center Drive, Suite 107, Mt. Prospect, IL 60056.