Volvo 2006 S60 Owner's Manual - page 144
2006 Volvo S60
the center control panel is pressed.
R-models only:
The AYC function can be deactivated. This is done by pressing the DSTC button on the center control
panel (see the illustration on
page 29
) for approximately one second. This procedure must be repeated 5
times, after which "DSTC REDUCED FUNCTION" will be displayed in the text window. AYC will be
automatically reactivated the next time the ignition is switched on.
WARNING!
With AYC disabled, the car's handling and stability characteristics will be
altered.
pg. 99 Starting and driving
The STC/DSTC button
The STC/DSTC button in the center control panel (see
page 29
) is used to switch the Spin Control (SC)
function on or off
NOTE: AYC (on models equipped with this function) will also be reduced, but not switched off, if SC
is switched off.
The button must be pressed for at least a half second to prevent SC from being switched off
inadvertently.
When the function has been switched off, the green indicator lamp in the button will go out and "STC/
DSTC SPIN CONTROL OFF" will be displayed in the text window.
All STC/DSTC functions are (re)activated each time the engine is started.
The Stability Control indicator light
The Stability Control indicator light will come on for approximately 2 seconds when the ignition is
switched on as the system performs a self-diagnostic test.
The Stability Control indicator light will flash when:
●
Traction Control is actively functioning to help avoid drive-wheel spin.
●
Spin Control is actively functioning to help avoid loss of traction during acceleration.
●
Active Yaw Control is actively functioning to help avoid skids or lateral slides.
file:///K|/ownersdocs/2006/2006_S60/06s60_08b.htm (2 of 15)12/30/2006 4:47:16 PM