Volvo 2006 S60 Owner's Manual - page 88
2006 Volvo S60
Repeat steps 3 and 4 to program the other two transceiver buttons.
If, after several attempts, you are unable to successfully train the HomeLink® Universal Transceiver to
learn your hand-held transmitter's signal, contact HomeLink® toll-free 1-800-355-3515 (Internet:
www.
HomeLink.com
).
pg. 195 Audio
WARNING!
If you use HomeLink® to open a garage door or gate, be sure no one is near the gate or door while it
is in motion.
Do not use the HomeLink® Universal Transceiver with any garage door opener that lacks safety
"stop" and "reverse" features as required by federal safety standards. (This includes any garage door
opener model manufactured before April 1, 1982) A garage door opener that cannot "detect" an
object, signaling the door to "stop" and "reverse" does not meet current federal safety standards.
Using a garage door opener without these features increases the risk of serious injury or death. For
more information on this matter, call toll-free 1-800-355-3515
(Internet:
www.HomeLink.com
).
NOTE: Canadian residents:
During programming, your hand-held transmitter may automatically stop transmitting. To successfully
train HomeLink®, continue to hold the HomeLink® button. At the same time, repeatedly press and hold
your hand-held transmitter's button at two-second intervals until HomeLink® has learned your
transmitter's code. The HomeLink® indicator light will flash first slowly, and then rapidly to indicate
that the button has been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a rolling code system and is
manufactured after 1996:
●
Refer to the garage door opener owner's manual for verification.
●
If your hand-held transmitter appears to program the HomeLink® Universal Transceiver but the
programmed button does not activate the garage door, your garage door opener may have a rolling code.
●
Press the programmed HomeLink® button. If the garage door opener has the rolling code feature, the
HomeLink® indicator light flashes rapidly and then glows steadily after approximately 2 seconds.
To train a rolling code garage door opener,
file:///K|/ownersdocs/2006/2006_S60/06s60_04b.htm (10 of 12)12/30/2006 4:47:12 PM