Volvo 2006 S60 Owner's Manual - page 87
2006 Volvo S60
HomeLink® Universal Transceiver
HomeLink® is an advanced system that can be programmed to learn the codes of three different remote
controlled-devices (e.g., garage door openers, remote lighting, entry door lock). HomeLink® 's sun visor-
mounted transceiver, powered by your car's electrical system, may then be used in place of your hand-
held remote controls.
NOTE: For your security, the HomeLink® Universal Transceiver is designed to not function if you lock
your car from the outside.
Programming the transceiver
1. The ignition switch must be turned to the "accessory" position (II) before programming the
HomeLink® Universal Transceiver.
2. Begin by erasing all 3 factory default channels. Hold down the two outside buttons (buttons 1 and 3 in
the illustration) on the HomeLink® Universal Transceiver for about 20 seconds, until HomeLink®'s
indicator light begins to flash. Then release the buttons.
3. Hold your hand-held transmitter (garage door opener, for example) 2 to 5 in. (5 to 12 cm) away from
the HomeLink® surface, keeping the indicator light in view. For placement questions, contact
HomeLink® toll-free 1-800-355-3515 (Internet:
www.HomeLink.com
).
4.Using two hands, push and hold both your hand-held transmitter's button and the transceiver button
you wish to program. The indicator light will flash first slowly, then rapidly. Rapid flashing tells you the
HomeLink® button has been successfully programmed. Release both buttons.
5. If you are programming a rolling code-equipped device (e.g., garage door opener or entry door lock),
refer to "Programming rolling codes" on the next page to complete the programming process.
file:///K|/ownersdocs/2006/2006_S60/06s60_04b.htm (9 of 12)12/30/2006 4:47:12 PM